The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during power window regulator motor removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learming the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH and LH sides.
Use the same procedure described for the LH side.
Before performing disassembly work on the front door, make sure that the front door glass is fully open and be sure to disconnect the cable from the negative (-) battery terminal.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
After turning the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
69278B
3.REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH
4.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
67602
6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
68172A
7.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH
68195B
8.REMOVE FRONT DOOR REAR BELT SEAL LH
68193C
9.REMOVE FRONT DOOR FRONT BELT SEAL LH
86160
10.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY
67626A
11.REMOVE NO. 2 DOOR TRIM BRACKET
67832
12.REMOVE FRONT DOOR SERVICE HOLE COVER LH
67838F
13.REMOVE FRONT DOOR NO. 4 SERVICE HOLE COVER LH (w/ Curtain Shield Airbag)
68151D
14.DISCONNECT FRONT DOOR GLASS RUN LH
67402F
15.REMOVE FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY LH
68102
16.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
68151D
17.REMOVE FRONT DOOR GLASS RUN LH
67834
18.REMOVE FRONT DOOR NO. 2 SERVICE HOLE COVER LH
69820
19.REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY LH
85720C
20.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Using a T25 "TORX" socket wrench, remove the 3 "TORX" screws and power window regulator motor assembly LH from the front door window regulator sub-assembly LH.