87030A
1.REMOVE REAR COOLING UNIT ASSEMBLY
87103D
2.REMOVE REAR BLOWER WITH FAN MOTOR SUB-ASSEMBLY
Detach the clamp.
Disconnect each connector and remove each cooling wire harness.
Remove each hose.
Detach the claw and remove the pipe clamp.
Remove the 7 screws, detach the guide and remove the rear cooling unit case LH.
Remove the 8 screws, detach the guide and remove the rear cooling unit case RH.
Remove the 3 screws and rear blower with fan motor sub-assembly.
Use the same procedure for the other side.
Removing the rear cooling unit case makes it possible to remove the rear blower with fan motor sub-assembly without disassembling the rear cooling unit assembly.