The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear curtain shield airbag assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>1GD-FTV BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
3.REMOVE ROOF HEADLINING ASSEMBLY
62180E
4.REMOVE REAR CURTAIN SHIELD AIRBAG ASSEMBLY LH
|
Deployment Side |
When storing the rear curtain shield airbag assembly LH, keep the airbag deployment side facing upward.
If the airbag deploys for any reason, it may cause a serious accident.
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Disconnect the airbag connector.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR
Remove the rear curtain shield airbag assembly LH deployment portion in the following order.
| *1 | Roof Side Inner Garnish Clip | - | - |
|
Remove in this Direction | - | - |
Using needle-nose pliers, remove the 5 pins from the 4 clips and roof side inner garnish clip.
Using 2 thin bladed screwdrivers, detach the claw and remove the 4 clips and roof side inner garnish clip together with the rear curtain shield airbag assembly LH deployment portion.
Remove the rear curtain shield airbag assembly LH inflator in the following order.
The bolt must not be reused.
Remove the bolt and rear side of the rear curtain shield airbag assembly LH deployment portion.
Remove the 2 bolts.
Detach the hook to remove the rear curtain shield airbag assembly LH inflator.
When reusing the rear curtain shield airbag assembly LH:
Do not reuse the clip and roof side inner garnish clip.
| *1 | Clip | *2 | Curtain Shield Airbag Clip Spacer |
| *3 | Roof Side Inner Garnish Clip | - | - |
Detach the claw and remove the clip and curtain shield airbag clip spacer.
Detach the claw and remove the 3 clips and roof side inner garnish clip.