Home › Engine / Hybrid System › 7GR-FKS (INTAKE / EXHAUST) › EXHAUST PIPE
RM35X0E _51 Engine / Hybrid System _079308 7GR-FKS INTAKE / EXHAUST _0385728 EXHAUST PIPE A

7GR-FKS INTAKE / EXHAUST  EXHAUST PIPE  INSTALLATION  


PROCEDURE

Hide 17430 1.INSTALL TAILPIPE ASSEMBLY

a.

Install the tailpipe assembly to the exhaust pipe support.


Hide 17420 2.INSTALL CENTER EXHAUST PIPE ASSEMBLY

a.

Install a new gasket to the center exhaust pipe assembly.


b.

Connect the 3 exhaust pipe supports and install the center exhaust pipe assembly.

A437903C01
0.052,0.052 0.365,0.208 0.313,0.156 10 false *A 3.656,0.052 3.969,0.208 0.313,0.156 10 false *B
*A for High Roof *B for Standard Roof



c.

Install the center exhaust pipe assembly to the tailpipe assembly with the 2 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 89465 3.INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 1)

Hide 89465 4.INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 1)

Hide 17450B 5.INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY

Hide 17410 6.INSTALL FRONT EXHAUST PIPE ASSEMBLY

Hide 17403 7.INSTALL FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY

a.

Install a new gasket to the front No. 3 exhaust pipe sub-assembly.


b.

Connect the 2 exhaust pipe supports.


c.

Install the front No. 3 exhaust pipe sub-assembly to the front exhaust pipe, front No. 2 exhaust pipe and center exhaust pipe assembly with the 6 bolts and 2 compression springs.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)

A437901C01
0.052,0.052 0.365,0.208 0.313,0.156 10 false *A 3.656,0.052 3.969,0.208 0.313,0.156 10 false *B
*A w/ Secondary Air Injection System *B w/o Secondary Air Injection System



Hide 8.INSPECT FOR EXHAUST GAS LEAK

If gas leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.

HINT:

If an exhaust gas leak has been repaired, perform an inspection following the repair (See page Engine / Hybrid System>7GR-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION).


Hide 51405A 9.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 52618 10.INSTALL LOWER FRONT BUMPER ABSORBER

Hide 51406A 11.INSTALL NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)