Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM › 2019.02–2019.06
RM35X0E _56 Audio / Visual / Telematics _079315 PARK ASSIST / MONITORING _0385736 PARKING ASSIST MONITOR SYSTEM C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  C1691  Back Camera Initialization Incomplete  


DESCRIPTION

This DTC is stored when the television camera assembly judges that the back camera initial setting has not been memorized (television camera assembly optical axis adjustment [back camera position setting] is incomplete).

DTC No. Detection Item DTC Detection Condition Trouble Area
C1691 Back Camera Initialization Incomplete Back camera initial setting has not been memorized (television camera assembly optical axis adjustment [back camera position setting] is incomplete)
·

Television camera assembly optical axis adjustment (back camera position setting)

·

Television camera assembly



CAUTION / NOTICE / HINT

NOTICE:
·

If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point".

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION



PROCEDURE

1.PERFORM CALIBRATION
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the television camera assembly.

i.

Television camera assembly optical axis adjustment (back camera position setting).

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION



Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR

Chassis > Rear Camera > Clear DTCs
50002 85

b.

Recheck for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR

Chassis > Rear Camera > Trouble Codes
50001 85
HINT:
·

If DTC C1691 is output, perform the television camera assembly optical axis adjustment (back camera position setting) again.

·

If DTC C1691 is still output after performing the television camera assembly optical axis adjustment 3 times, replace the television camera assembly.




Result:
Result Proceed to
DTC C1691 is not output A
DTC C1691 is output B



A

END

B