Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for ERA-GLONASS) › 2019.02–2021.07
RM35X0E _56 Audio / Visual / Telematics _078380 TELEMATICS _0385046 TELEMATICS SYSTEM(for ERA-GLONASS) C

TELEMATICS  TELEMATICS SYSTEM(for ERA-GLONASS)  B1573  Short in Telephone Antenna Circuit  B15CB  Telephone Antenna Disconnected  


DESCRIPTION

These DTCs are stored when a malfunction occurs in the telephone antenna.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1573 Short in Telephone Antenna Circuit No. 2 amplifier antenna assembly impedance (Ω) is lower than the malfunction threshold for 10 seconds or more when the ignition switch is ON.
(Short circuit)
·

Telephone transceiver assembly

·

No. 2 amplifier antenna assembly

·

No. 2 antenna cord sub-assembly

·

Harness or connector


B15CB Telephone Antenna Disconnected No. 2 amplifier antenna assembly impedance (Ω) is higher than the malfunction threshold for 10 seconds or more when the ignition switch is ON.
(Open circuit)
·

Telephone transceiver assembly

·

No. 2 amplifier antenna assembly

·

No. 2 antenna cord sub-assembly

·

Harness or connector



WIRING DIAGRAM

E409654E03
0.875,1.833 2.375,2.219 1.5,0.385 10 false No. 2 Amplifier Antenna Assembly 2.917,1.823 4.427,2.51 1.51,0.688 10 false No. 2 Antenna Cord Sub-assembly 2.573,0.833 4.083,1.521 1.51,0.688 10 false A 2.583,1.448 4.094,2.135 1.51,0.688 10 false A 2.573,0.646 4.083,1.333 1.51,0.688 10 false 1 2.563,1.24 4.073,1.927 1.51,0.688 10 false 1a 4.094,0.844 5.604,1.531 1.51,0.688 10 false TEL 4.469,1.438 5.979,2.125 1.51,0.688 10 false N139 4.552,1.24 6.063,1.927 1.51,0.688 10 false 1a 4.552,0.625 6.063,1.313 1.51,0.688 10 false 1 5.5,2.302 7.01,2.99 1.51,0.688 10 false N138 5.396,1.323 6.906,2.01 1.51,0.688 10 false 1a 5.448,0.729 6.958,1.417 1.51,0.688 10 false 1 5.51,2.479 6.896,2.865 1.385,0.385 10 false Telephone Transceiver Assembly 4.469,0.854 5.979,1.542 1.51,0.688 10 false N139 5.719,0.865 7.052,1.583 1.333,0.719 10 false ANT1

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>REGISTRATION

·

When replacing the telephone transceiver assembly, make sure to replace it with a new one.



PROCEDURE

1.CHECK DTC
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON and wait for 20 seconds.


d.

Turn the GTS on.


e.

Check for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>DTC CHECK / CLEAR

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

2.INSPECT NO. 2 AMPLIFIER ANTENNA ASSEMBLY
2.INSPECT NO. 2 AMPLIFIER ANTENNA ASSEMBLY
a.

Remove the No. 2 amplifier antenna assembly.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AMPLIFIER ANTENNA>REMOVAL


b.
E409657C01
1.833,1.375 2.229,1.729 true 0.125,0.104 0.438,0.302 0.313,0.198 10 false *a 2.271,1.708 2.583,1.906 0.313,0.198 10 false 1a
*a Component without harness connected
(No. 2 Amplifier Antenna Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 1a Always 4 to 11 kΩ



Result:
Proceed to
OK
NG



OK

3.INSPECT NO. 2 ANTENNA CORD SUB-ASSEMBLY

NG

REPLACE NO. 2 AMPLIFIER ANTENNA ASSEMBLY

3.INSPECT NO. 2 ANTENNA CORD SUB-ASSEMBLY
a.
E409656C01
1.51,0.219 1.875,0.469 0.365,0.25 1.5,1.885 1.896,2.135 0.396,0.25 1.885,1.115 2.427,0.656 2.427,0.656 2.563,0.656 true 1.813,2.75 2.385,2.354 2.385,2.354 2.521,2.354 true 1.646,2.74 1.135,2.375 1.135,2.375 0.99,2.375 true 2.635,0.594 2.948,0.792 0.313,0.198 10 false 1a 2.563,2.281 2.875,2.479 0.313,0.198 10 false 1a 0.542,0.219 0.854,0.417 0.313,0.198 10 false *a 0.583,1.865 0.896,2.063 0.313,0.198 10 false *b 1.635,0.26 1.948,0.458 0.313,0.198 10 false A 1.542,1.927 2.479,2.406 0.938,0.479 10 false N139 0.708,2.302 1.167,2.5 0.458,0.198 10 false TEL
*a Front view of wire harness connector
(to No. 2 Amplifier Antenna Assembly)
*b Front view of wire harness connector
(to Wire harness)


Disconnect the No. 2 antenna cord sub-assembly from the No. 2 amplifier antenna assembly connector.


b.

Disconnect the No. 2 antenna cord sub-assembly from the wire harness connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A-1 - N139-1 (TEL) Always Below 1 Ω
A-1a - N139-1a Always Below 1 Ω
A-1 or N139-1 (TEL) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.CHECK HARNESS AND CONNECTOR (NO. 2 ANTENNA CORD SUB-ASSEMBLY -TELEPHONE TRANSCEIVER ASSEMBLY)

NG

4.CHECK HARNESS AND CONNECTOR (NO. 2 ANTENNA CORD SUB-ASSEMBLY -TELEPHONE TRANSCEIVER ASSEMBLY)
a.
E409656C02
1.51,0.219 1.958,0.469 0.448,0.25 1.469,1.875 1.917,2.125 0.448,0.25 1.885,1.104 2.427,0.656 2.427,0.656 2.563,0.656 true 1.813,2.74 2.385,2.354 2.385,2.354 2.521,2.354 true 1.729,1.177 1.104,0.802 1.104,0.802 0.958,0.802 true 1.625,2.771 1.292,2.396 1.292,2.396 1.146,2.396 true 2.635,0.594 2.948,0.792 0.313,0.198 10 false 1a 2.563,2.281 2.875,2.479 0.313,0.198 10 false 1a 0.542,0.219 0.854,0.417 0.313,0.198 10 false *a 0.583,1.865 0.896,2.063 0.313,0.198 10 false *b 1.583,0.26 2.042,0.583 0.458,0.323 10 false N139 1.531,1.927 2.188,2.365 0.656,0.438 10 false N138 0.729,0.729 1.042,0.927 0.313,0.198 10 false TEL 0.75,2.333 1.292,2.625 0.542,0.292 10 false ANT1
*a Front view of wire harness connector
(to No. 2 Antenna Cord Sub-assembly)
*b Front view of wire harness connector
(to Telephone Transceiver Assembly)


Disconnect the No. 2 antenna cord sub-assembly connector.


b.

Disconnect the telephone transceiver assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
N139-1 (TEL) - N138-1 (ANT1) Always Below 1 Ω
N139-1a - N138-1a Always Below 1 Ω
N139-1 (TEL) or N138-1 (ANT1) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

5.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS AND CONNECTOR

5.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
a.

Replace the telephone transceiver assembly with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER (for LHD)>REMOVAL


Result:
Proceed to
NEXT



NEXT