Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD (for Roof Side) › 2019.02–2019.06
RM35X0E _56 Audio / Visual / Telematics _078377 AUDIO / VIDEO _0380030 RADIO ANTENNA CORD(for Roof Side) A

AUDIO / VIDEO  RADIO ANTENNA CORD(for Roof Side)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the No. 2 antenna cord sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*: w/ Stop and start system

Stop and start system* Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). (Click here)
Lane control system Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more. (Click here)
Pre-collision system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power slide door system Fully close the slide door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the slide door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION (w/ Airbag System)

CAUTION:
B407254

Be sure to read Precaution thoroughly before servicing.



NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Airbag System)


CAUTION:
B422343

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



Hide 86101J 4.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (for Standard Roof)

a.

w/o Digital Audio Broadcasting Antenna:

i.
E410020C01
2.479,2.917 2.854,3.135 true 1.083,2.188 0.813,0.417 0.813,0.417 2.896,0.302 true 1.625,1.656 0.833,0.427 0.833,0.427 2.167,0.802 true 2.865,3.01 3.063,3.24 0.198,0.229 10 true *b 0.646,0.292 0.844,0.521 0.198,0.229 10 true *a
*a Clamp
*b Guide
V100135

Bolt
V100136

Connector


Disconnect the 2 connectors.


ii.

Remove the bolt.


iii.

Detach the clamp and guide and remove the No. 2 antenna cord sub-assembly.



b.

w/ Digital Audio Broadcasting Antenna:

i.
E410019C01
0.875,4.24 1.208,4.24 true 2.063,2.74 0.813,2.531 0.813,2.531 1.063,1.917 true 1.948,0.469 2.281,0.469 true 2.375,2.375 0.823,2.531 0.823,2.531 1.74,1.917 true 2.979,1.448 2.344,1.563 2.344,1.563 2.688,1.792 true 2.396,1.781 2.344,1.563 true 0.75,4.146 1,4.417 0.25,0.271 10 true *b 2.219,0.375 2.469,0.646 0.25,0.271 10 true *b 0.635,2.438 0.885,2.708 0.25,0.271 10 true *a 2.094,1.448 2.344,1.719 0.25,0.271 10 true *a
*a Clamp
*b Guide
V100135

Bolt
V100136

Connector


Disconnect the 3 connectors.


ii.

Remove the 2 bolts.


iii.

Detach the clamp and guide and remove the No. 2 antenna cord sub-assembly.



Hide 86101J 5.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (for High Roof)

a.

for Standard:

i.
E410022C01
1.646,2.917 1.906,2.969 true 0.844,2.271 0.573,0.5 0.573,0.5 2.677,0.313 true 1.052,1.906 0.563,0.521 0.563,0.521 2.302,0.625 true 1.292,1.521 0.552,0.531 0.552,0.531 2.01,0.885 true 0.604,0.563 1.729,1.219 true 1.479,2.802 1.677,3.031 0.198,0.229 10 true *b 0.448,0.417 0.646,0.646 0.198,0.229 10 true *a
*a Clamp
*b Guide
V100135

Bolt
V100136

Connector


Disconnect the 2 connectors.


ii.

Remove the bolt.


iii.

Detach the clamp and guide and remove the No. 2 antenna cord sub-assembly.



b.

w/ Digital Audio Broadcasting Antenna:

i.
E410021C01
0.833,4.167 1.167,4.167 true 1.698,3.188 0.635,3.271 0.635,3.271 0.885,2.656 true 1.333,0.229 1.667,0.229 true 1.875,2.938 0.615,3.271 0.615,3.271 1.375,2.656 true 2.646,1.719 1.875,1.719 1.875,1.719 1.844,2.531 true 2.031,2.448 1.875,1.74 1.875,1.74 2.427,1.896 true 2.125,2.313 1.875,1.74 1.875,1.74 2.292,2.052 true 0.646,4.052 0.896,4.323 0.25,0.271 10 true *b 1.656,0.146 1.906,0.417 0.25,0.271 10 true *b 0.427,3.135 0.677,3.406 0.25,0.271 10 true *a 1.667,1.573 1.927,1.771 0.26,0.198 10 true *a
*a Clamp
*b Guide
V100135

Bolt
V100136

Connector


Disconnect the 3 connectors.


ii.

Remove the 2 bolts.


iii.

Detach the clamp and guide and remove the No. 2 antenna cord sub-assembly.



c.

for ERA-GLONASS:

i.
E416938C01
0.917,4 1.333,4 true 0.833,0.583 0.75,1.917 0.75,1.917 1.833,2.417 true 1.25,0.552 0.75,1.917 0.75,1.917 2,2.167 true 1.75,0.667 0.75,1.917 0.75,1.917 2,1.667 true 2.5,1.5 3.083,1.885 3.083,1.885 3.083,0.719 true 2.667,1.167 3.073,1.865 3.073,1.865 2.917,0.917 true 0.833,3.906 1.042,4.115 0.208,0.208 10 true *b 0.583,1.833 0.833,2.083 0.25,0.25 10 true *a 3,1.833 3.25,2.083 0.25,0.25 10 true *a
*a Clamp
*b Guide
V100135

Bolt
V100136

Connector


Disconnect the 4 connectors.


ii.

Remove the bolt.


iii.

Detach the clamp and guide and remove the No. 2 antenna cord sub-assembly.