Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for ERA-GLONASS) › 2019.02–2019.06
RM35X0E _56 Audio / Visual / Telematics _078380 TELEMATICS _0385046 TELEMATICS SYSTEM(for ERA-GLONASS) C

TELEMATICS  TELEMATICS SYSTEM(for ERA-GLONASS)  B1583  GPS Signal Unreceived  


DESCRIPTION

This DTC is stored when GNSS satellite signals is not received for 30 km.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1583 GPS Signal Unreceived GNSS signals are not received for 30 km.
·

Telephone transceiver assembly

·

Navigation Antenna Assembly

·

Antenna cord sub-assembly

·

Harness or connector



WIRING DIAGRAM

E409654E04
0.875,1.833 2.115,2.635 1.24,0.802 10 false Navigation Antenna Assembly 3.01,1.823 4.219,2.542 1.208,0.719 10 false Antenna Cord Sub-assembly 2.573,0.833 4.083,1.521 1.51,0.688 10 false B 2.594,1.448 4.104,2.135 1.51,0.688 10 false B 2.573,0.646 4.083,1.333 1.51,0.688 10 false 3 2.563,1.24 4.073,1.927 1.51,0.688 10 false 3a 4.479,0.844 5.99,1.531 1.51,0.688 10 false N141 4.469,1.427 5.979,2.115 1.51,0.688 10 false N141 4.552,1.24 6.063,1.927 1.51,0.688 10 false 1a 4.552,0.625 6.063,1.313 1.51,0.688 10 false 1 5.5,2.25 5.958,2.427 0.458,0.177 10 false N140 5.396,1.323 6.906,2.01 1.51,0.688 10 false 1a 5.448,0.729 6.958,1.417 1.51,0.688 10 false 1 5.51,2.427 6.906,2.792 1.396,0.365 10 false Telephone Transceiver Assembly 5.729,0.854 7.104,1.615 1.375,0.76 10 false ANT2 4,0.854 5.375,1.615 1.375,0.76 10 false GPS

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>REGISTRATION

·

When replacing the telephone transceiver assembly, make sure to replace it with a new one.



PROCEDURE

1.MOVE VEHICLE
a.

If the vehicle is outside the communication service area, move the vehicle into a communication service area, wait for a while and perform the operation again.


Result:
Proceed to
NEXT



NEXT

2.CHECK DTC
2.CHECK DTC
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON and wait for 20 seconds.


d.

Turn the GTS on.


e.

Check for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>DTC CHECK / CLEAR

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

3.CHECK OPTIONAL COMPONENTS
3.CHECK OPTIONAL COMPONENTS
a.

Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.

Result:
Result Proceed to
Optional components are not installed A
Optional components are installed B


NOTICE:

Do not remove optional components without the permission of the customer.




A

4.CHECK DTC

B

REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE)

4.CHECK DTC
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>DTC CHECK / CLEAR

Body Electrical > Telematics > Trouble Codes
50001 233

b.

Recheck for DTCs and check if the same DTC is output again.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>DTC CHECK / CLEAR

Body Electrical > Telematics > Trouble Codes
50001 233

Result:
Result Proceed to
No DTCs are output. A
DTC B1583 is output. B



A

END

B

5.INSPECT ANTENNA CORD SUB-ASSEMBLY
5.INSPECT ANTENNA CORD SUB-ASSEMBLY
a.
E409655C01
1.521,1.917 1.938,2.156 0.417,0.24 1.469,0.156 1.885,0.396 0.417,0.24 1.875,0.875 2.448,1.208 2.448,1.208 2.604,1.208 true 1.813,2.781 2.25,2.5 2.25,2.5 2.406,2.5 true 1.646,2.792 1.281,2.469 1.281,2.469 1.135,2.469 true 1.573,1.948 2.073,2.292 0.5,0.344 10 false N141 0.573,0.125 0.885,0.323 0.313,0.198 10 false *a 0.625,1.854 0.938,2.052 0.313,0.198 10 false *b 1.625,0.198 1.938,0.396 0.313,0.198 10 false B 2.646,1.115 2.958,1.313 0.313,0.198 10 false 3a 2.427,2.417 2.74,2.615 0.313,0.198 10 false 1a 0.802,2.396 1.302,2.74 0.5,0.344 10 false GPS
*a Front view of wire harness connector
(to Navigation Antenna Assembly)
*b Front view of wire harness connector
(to Wire Harness)


Disconnect the antenna cord sub-assembly from the navigation antenna assembly connector.


b.

Disconnect the antenna cord sub-assembly from the wire harness connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
B-3 - N141-1 (GPS) Always Below 1 Ω
B-3a - N141-1a Always Below 1 Ω
B-3 or N141-1 (GPS) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

6.CHECK HARNESS AND CONNECTOR (ANTENNA CORD SUB-ASSEMBLY - TELEPHONE TRANSCEIVER ASSEMBLY)

NG

6.CHECK HARNESS AND CONNECTOR (ANTENNA CORD SUB-ASSEMBLY - TELEPHONE TRANSCEIVER ASSEMBLY)
a.
E409658C01
1.479,1.969 1.896,2.208 0.417,0.24 1.5,0.208 1.917,0.458 0.417,0.25 1.865,1.115 2.156,0.833 2.156,0.833 2.292,0.833 true 1.781,2.802 2.125,2.458 2.125,2.458 2.26,2.458 true 1.719,1.188 1.052,0.875 1.052,0.875 0.927,0.875 true 1.625,2.885 1.073,2.5 1.073,2.5 0.948,2.5 true 0.688,0.198 1,0.396 0.313,0.198 10 false *a 0.708,1.885 1.021,2.083 0.313,0.198 10 false *b 1.521,2 2.177,2.396 0.656,0.396 10 false N140 2.313,2.375 2.969,2.771 0.656,0.396 10 false 1a 2.302,0.719 2.958,1.115 0.656,0.396 10 false 1a 1.552,0.25 2.208,0.646 0.656,0.396 10 false N141 0.604,0.813 1.26,1.208 0.656,0.396 10 false GPS 0.583,2.427 1.24,2.823 0.656,0.396 10 false ANT2
*a Front view of wire harness connector
(to Antenna Cord Sub-assembly)
*b Front view of wire harness connector
(to Telephone Transceiver Assembly)


Disconnect the antenna cord sub-assembly connector.


b.

Disconnect the telephone transceiver assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
N141-1 (GPS) - N140-1 (ANT2) Always Below 1 Ω
N141-1a - N140-1a Always Below 1 Ω
N141-1 (GPS) or N140-1 (ANT2) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

7.CHECK NAVIGATION ANTENNA ASSEMBLY

NG

REPAIR OR REPLACE HARNESS AND CONNECTOR

7.CHECK NAVIGATION ANTENNA ASSEMBLY
a.

Replace the navigation antenna assembly with a new or known good one.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AMPLIFIER ANTENNA>REMOVAL


b.

Clear the DTCs.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>DTC CHECK / CLEAR

Body Electrical > Telematics > Clear DTCs
50002 233

c.

Recheck for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>DTC CHECK / CLEAR

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END (NAVIGATION ANTENNA ASSEMBLY IS DEFECTIVE)

NG

8.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
8.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
a.

Replace the telephone transceiver assembly with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER (for LHD)>REMOVAL


Result:
Proceed to
NEXT



NEXT