Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear seat outer belt assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1. PRECAUTION (w/ Pretensioner and Force Limiter)
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Pretensioner and Force Limiter)
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
73370E
3.REMOVE REAR SEAT OUTER BELT ASSEMBLY LH
| *a | Buckle Button |
|
Protective Tape |
Using a thin-bladed screwdriver, push the buckle button to release the lock and disconnect the rear seat outer belt assembly LH.
Tape the thin-bladed screwdriver tip before use.
Use the same procedure for the RH side.
|
Place Hands Here |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Place your hands at the position and pull in the removal direction (1) shown in the illustration and detach the claw.
Pull in the removal direction (2) shown in the illustration and detach the guide and remove the cover.
|
Open in this Direction |
Using moulding remover D, detach the claw and open the cover as shown in the illustration.
Loosen the bolt.
w/ Pretensioner and Force Limiter:
| *a | Locking Button |
|
Release in this Direction |
|
Protective Tape |
Using a thin-bladed screwdriver, pull out the locking button to release the lock to disconnect the pretensioner connector as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
Remove the 2 bolts.
Detach the guide and remove the rear seat outer belt assembly LH.