Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK › 2019.02–2019.06
RM35X0E _58 Vehicle Interior _078336 DOOR LOCK _0387725 FRONT DOOR LOCK A

DOOR LOCK  FRONT DOOR LOCK  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front door lock assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Effect/Inoperative Function when Necessary Procedure not Performed Necessary Procedure Link
Removal and installation of battery terminal Parking assist monitor system Memorize steering angle neutral point (Click here)
·

Power window regulator motor assembly LH

·

Power window regulator motor assembly RH

·

Front door window regulator assembly LH

·

Front door window regulator assembly RH

·

Front door glass sub-assembly LH

·

Front door glass sub-assembly RH

·

Front door glass run LH

·

Front door glass run RH


·

Auto up and down function

·

Jam protection function

·

Catch protection function

·

Remote control function

·

Key-linked function

·

Wireless transmitter-linked function

·

Key-off operation function


Initialize power window control system (Click here)

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*: w/ Stop and start system

Stop and start system* Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). (Click here)
Lane control system Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power slide door system Fully close the slide door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the slide door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -

·

Use the same procedure for RHD and LHD vehicles.

·

The procedure below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure below is for the LH side.

·

When removing the front door glass sub-assembly LH, move the front door glass sub-assembly LH to the lowest position before disconnecting the negative (-) battery terminal.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


b.

for 1GD-FTV:

Click hereGeneral>MAINTENANCE>1GD-FTV BATTERY>REMOVAL

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




Hide 69278B 3.REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH

Hide 4.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

Hide 5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

Hide 67602 6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 68172A 7.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

Hide 68195B 8.REMOVE FRONT DOOR REAR BELT SEAL LH

Hide 68193C 9.REMOVE FRONT DOOR FRONT BELT SEAL LH

Hide 86160 10.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

Hide 67626A 11.REMOVE NO. 2 DOOR TRIM BRACKET

Hide 67832 12.REMOVE FRONT DOOR SERVICE HOLE COVER LH

Hide 67836C 13.REMOVE FRONT DOOR NO. 3 SERVICE HOLE COVER LH (w/ Curtain Shield Airbag)

Hide 67838F 14.REMOVE FRONT DOOR NO. 4 SERVICE HOLE COVER LH (w/ Curtain Shield Airbag)

Hide 68151D 15.DISCONNECT FRONT DOOR GLASS RUN LH

Hide 67402F 16.REMOVE FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY LH

Hide 68102 17.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 68151D 18.REMOVE FRONT DOOR GLASS RUN LH

Hide 67834 19.REMOVE FRONT DOOR NO. 2 SERVICE HOLE COVER LH

Hide 69820 20.REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY LH

Hide 67404F 21.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

Hide 69220 22.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH (w/ Lock Cylinder)

Hide 23.REMOVE FRONT DOOR LOCK CYLINDER ASSEMBLY LH (w/ Lock Cylinder)

Hide 69312 24.REMOVE FRONT DOOR LOCK OPEN ROD LH

a.
B537909C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)
V113149

Remove in this Direction (3)


Detach the snap in the direction (1) indicated by the arrow shown in the illustration and disconnect the front door lock open rod LH in the direction (2) indicated by the arrow shown in the illustration.


b.

Remove the front door lock open rod LH in the direction (3) indicated by the arrow shown in the illustration.


Hide 69040A 25.REMOVE FRONT DOOR LOCK WITH MOTOR ASSEMBLY LH

a.
B537911C01
0,0 0,0 false
V100135

"TORX" Screw
V100136

Connector


Disconnect the connector.


b.

Using a T30 "TORX" socket wrench, remove the 3 "TORX" screws and front door lock with motor assembly LH.


Hide 69318C 26.REMOVE DOOR LOCK WIRING HARNESS SEAL

a.
B537912

When reusing front door lock with motor assembly LH:

i.

Remove the door lock wiring harness seal from the front door lock with motor assembly LH.



Hide 69036A 27.REMOVE FRONT DOOR LOCK COVER SUB-ASSEMBLY LH

a.
B537913C01
0,0 0,0 false
V113147

Remove in this Direction
V100155

Protective Tape


Using a screwdriver with its tip wrapped with protective tape, detach the claw and open the front door lock cover sub-assembly LH.


b.
B537914

Detach the claw and remove the front door lock cover sub-assembly LH.


Hide 69720D 28.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

a.
B537915C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the clamp and remove the front door lock remote control cable assembly LH as shown in the illustration.


Hide 69760B 29.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

a.
B537916C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the clamp and remove the front door inside locking cable assembly LH as shown in the illustration.