Home › General › MAINTENANCE › 1GD-FTV BATTERY
RM35X0E _V1 General _078672 MAINTENANCE _0387106 1GD-FTV BATTERY A

MAINTENANCE  1GD-FTV BATTERY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 28800 1.INSTALL BATTERY

a.

Install the battery to the vehicle.


b.

Install the battery clamp with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the cable to the positive (+) battery terminal and tighten the nut.

Torque:
5.3 N*m (54 kgf*cm, 47 in.*lbf)


d.

Close the connector cover.


e.

w/o Stop And Start System:

i.

Install the battery service hole cover sub-assembly LH to the vehicle with the 5 bolts.

Torque:
13.5 N*m (138 kgf*cm, 10 ft.*lbf)


ii.

Attach the 2 claws and install the front door scuff plate LH with the 6 bolts.


iii.

Install the 2 front door outside scuff plate LH to the front door scuff plate LH.



Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

a.

w/o Stop And Start System:

i.

Connect the cable to the negative (-) battery terminal and tighten the nut.

Torque:
5.3 N*m (54 kgf*cm, 47 in.*lbf)


ii.

Install the front battery service hole cover sub-assembly LH to the side of the battery service hole cover.


iii.
A456442

Install the door scuff plate cover to the side of the front door scuff plate assembly LH and turn the 2 knobs left to lock it.



b.

w/ Stop And Start System:

i.

Connect the cable to the negative (-) battery terminal and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


ii.

Install the battery service hole cover sub-assembly LH to the vehicle with the 5 bolts.

Torque:
13.5 N*m (138 kgf*cm, 10 ft.*lbf)


iii.

Attach the 2 claws and install the front door scuff plate LH with the 6 bolts.


iv.

Install the 2 front door outside scuff plate LH to the front door scuff plate LH.



Hide 3. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART