The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the brake pedal support assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
73900
2.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
55646
3.REMOVE AND INSTALL NO. 3 INSTRUMENT PANEL UNDER COVER
87211
4.REMOVE NO. 1 AIR DUCT
44610
5.REMOVE BRAKE BOOSTER ASSEMBLY
84340
6.REMOVE STOP LIGHT SWITCH ASSEMBLY
84345
7.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
8.REMOVE BRAKE PEDAL RETURN SPRING
Remove the brake pedal return spring from the brake pedal support assembly.
47264A
9.REMOVE PUSH ROD PIN
Remove the clip and push rod pin.
47110
10.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
Remove the 2 clips from the brake pedal support assembly.
Remove the bolt and brake pedal support assembly from the instrument panel reinforcement assembly.
47121
11.REMOVE BRAKE PEDAL PAD