Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/o EGR Cooler)
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0388652 ECD SYSTEM(w/o EGR Cooler) C

1GD-FTV ENGINE CONTROL  ECD SYSTEM(w/o EGR Cooler)  P063051  VIN Not Programmed  


DESCRIPTION

DTC P063051 is set when the Vehicle Identification Number (VIN) or frame number is not stored in the ECM or the input VIN is not accurate. Input the VIN with the GTS.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P063051 VIN Not Programmed Either of the following conditions is met (1 trip detection logic):
·

The VIN or frame number is not stored in the ECM.

·

The VIN or frame number input into the ECM is not accurate.


·

VIN

·

ECM


Comes on DTC stored SAE Code: P0630

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P063051 Ignition switch ON for 5 seconds or more

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P063051)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 372

d.

Read the DTCs.

Result:
Result Proceed to
DTC P063051 is output A
DTC P063051 and other DTCs are output B


NOTICE:

If P063051 is set, the VIN must be input to the ECM using the GTS. However, all DTCs are cleared automatically by the GTS when inputting the VIN. If DTCs other than P063051 are set, check them first.


HINT:

If any DTCs other than P063051 are output, troubleshoot those DTCs first.




A

2.INPUT VIN OR FRAME NUMBER

B

2.INPUT VIN OR FRAME NUMBER

Result:
Proceed to
NEXT



NEXT

END