The ECM monitors the operation of the injector assembly and AT pressure control solenoid valve. When a malfunction is detected in the actuator cut circuit immediately after the engine switch is turned off, the ECM illuminates the MIL and stores a DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P16B09F | Actuator Cut Circuit Stuck Off | ECM main CPU malfunction (1 trip detection logic). | ECM | Comes on | DTC stored | SAE Code: P16B0 |
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P16B09F | Ignition switch off for 30 second or more |
After replacing the ECM, the new ECM needs registration (Click here Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o EGR Cooler)>REGISTRATION) and initialization (Click here Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o EGR Cooler)>INITIALIZATION).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs.
Turn the ignition switch off for 30 seconds or more.
Turn the ignition switch to ON.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| P16B09F is output | A |
| P16B09F and P062D00 are output | B |
| P16B09F and P17029F are output | C |
| No DTC is output | D |
When DTC P062D00 is displayed, follow the procedure of P062D00.
When DTC P17029F is displayed, follow the procedure of P17029F.
A
B
C
D
Replace the ECM.
Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Clear the DTCs.
Turn the ignition switch off for 30 seconds or more.
Turn the ignition switch to ON.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Confirm that the DTC is not output again.
| Proceed to |
|---|
| NEXT |
NEXT