Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/ Exhaust Gas Temperature Sensor for EGR) › 2019.06–2021.07
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0395991 ECD SYSTEM(w/ Exhaust Gas Temperature Sensor for EGR) C

1GD-FTV ENGINE CONTROL  ECD SYSTEM(w/ Exhaust Gas Temperature Sensor for EGR)  P029900  Turbocharger/Supercharger "A" Underboost Condition  


DESCRIPTION

Refer to DTC P004512.

Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Exhaust Gas Temperature Sensor for EGR)>P004512

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P029900 Turbocharger/Supercharger "A" Underboost Condition The pressure is 33 to 134 kPa below the Target Boost Pressure for 20 seconds at an engine speed of 1600 to 3600 rpm and Injection Volume of 30 to 100 mm3/st (2 trip detection logic)
·

Turbo charger sub-assembly

·

Extremely low battery voltage (P056014 output simultaneously)

·

Disconnected pipe between turbocharger and intake manifold

·

Disconnected manifold absolute pressure sensor hose

·

Throttle valve stuck closed

·

Electric EGR control valve assembly does not close

·

Exhaust system or intake system modified (leading to increased pressure loss, etc.)

·

Manifold absolute pressure sensor

·

Injection system (reduction in fuel injection volume)

·

Fuel filter element assembly clog

·

ECM


Class B2 DTC stored SAE Code: P0299

Related Data List
DTC No. Data List
P029900
·

Target Boost Pressure

·

Intake Manifold Absolute Pressure

·

Target Fuel Pressure (High)

·

Fuel Pressure (High)



HINT:

If DTC P029900 is stored due to the variable nozzle being stuck open, the following symptoms may appear:

-

Lack of power

-

Vehicle surge or hesitation under light or medium load




CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P029900 Accelerate vehicle with accelerator depressed halfway or more starting from a speed of 120 km/h (75 mph) or more for 2 minutes (make sure gear is fixed and does not change)

CAUTION / NOTICE / HINT

NOTICE:


HINT:
·

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

·

The state of the problem symptom can be determined by comparing the Data List items "Intake Manifold Absolute Pressure" and "Target Boost Pressure" while accelerating at a medium to high engine speed.



PROCEDURE

1.CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P029900)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG) and turn the GTS on.


c.

Enter the following menus: Powertrain / Engine and Transmission / Trouble Codes.

Powertrain > Engine and Transmission > Trouble Codes
50001 456

d.

Read the DTCs.

Result:
Result Proceed to
DTC P029900 is output A
DTC P029900 and other DTCs are output B




A

2.CHECK FREEZE FRAME DATA (FUEL PRESSURE (HIGH) AND TARGET FUEL PRESSURE (HIGH))

B

2.CHECK FREEZE FRAME DATA (FUEL PRESSURE (HIGH) AND TARGET FUEL PRESSURE (HIGH))
a.

Enter the following menus: Powertrain / Engine and Transmission / Trouble Codes.

Powertrain > Engine and Transmission > Trouble Codes
50001 456

b.

Record the stored DTCs and freeze frame data.

Result:
Result Proceed to
Difference between Fuel Pressure (High) and Target Fuel Pressure (High) of freeze frame data is 20000 kPag or more A
Except above B




A

B