Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
71848R
1.REMOVE FRONT NO. 1 SEAT ADJUSTER COVER CAP LH
|
Remove in this Direction |
Remove the front No. 1 seat adjuster cover cap LH as shown in the illustration.
71848S
2.REMOVE FRONT NO. 2 SEAT ADJUSTER COVER CAP LH
|
Remove in this Direction |
Remove the front No. 2 seat adjuster cover cap LH as shown in the illustration.
71139P
3.REMOVE FRONT SEAT OUTER LEG COVER LH
Remove the clip.
Remove the screw.
|
Place Hand Here |
|
Remove in this Direction |
Place your hand at the position and pull in the removal direction shown in the illustration and detach the clip and guide.
|
Place Hand Here |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Place your hand at the position shown in the illustration and pull in the removal direction (1).
Pull in the removal direction (2) shown in the illustration, detach the guide and remove the front seat outer leg cover LH.
71139Q
4.REMOVE FRONT SEAT INNER LEG COVER LH
Use the same procedure described for the front seat outer leg cover LH.
71140A
5.REMOVE FRONT SEAT LEG ASSEMBLY LH
| *A | w/ Front Seat Side Airbag |
| *B | w/ Seat Position Airbag Sensor |
Detach the claw and clamp.
Remove the 3 clips.
Remove the 5 nuts and front seat leg assembly LH.
71862K
6.REMOVE FRONT SEAT INNER CUSHION SHIELD LH
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver, detach the claw as shown in the illustration.
Tape the screwdriver tip before use.
|
Remove in this Direction |
Detach the claw and guide as shown in the illustration.
|
Remove in this Direction |
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
|
Remove in this Direction |
Detach the guide as shown in the illustration.
| *1 | Front seat front cushion shield LH |
|
Remove in this Direction |
Detach the claw and guide and remove the front seat inner cushion shield LH as shown in the illustration.
Remove the front seat inner cushion shield LH together with the front seat front cushion shield LH.
71867X
7.REMOVE FRONT SEAT FRONT CUSHION SHIELD LH
Remove the screw.
Detach the claw and remove the front seat front cushion shield LH.
71812T
8.REMOVE FRONT SEAT CUSHION SHIELD LH
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver, detach the claw as shown in the illustration.
Tape the screwdriver tip before use.
|
Remove in this Direction |
Detach the claw and guide as shown in the illustration.
|
Remove in this Direction |
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
|
Remove in this Direction |
Detach the guide as shown in the illustration.
Disconnect the connector and remove the front seat cushion shield LH.
84921B
9.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
|
Remove in this Direction |
Using moulding remover A, detach the claw and remove the slide and vertical power seat switch knob.
84921A
10.REMOVE RECLINING POWER SEAT SWITCH KNOB
|
Remove in this Direction |
Using moulding remover A, detach the claw and remove the reclining power seat switch knob.
84922
11.REMOVE FRONT POWER SEAT SWITCH
73240
12.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
71705G
13.REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH
Detach the band.
|
Remove in this Direction |
Remove the 2 screws.
Detach the hook and remove the front seatback board sub-assembly LH as shown in the illustration.
82192
14.REMOVE FRONT NO. 1 SEAT WIRE LH
| *A | w/ Seat Position Airbag Sensor |
| *B | w/ Front Seat Side Airbag |
Disconnect the each connector.
Detach the clamp and remove the front No. 1 seat wire LH.
15.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
| *A | w/ Front Seat Side Airbag |
Disconnect the connector.
w/ Front Seat Side Airbag:
Detach the claw.
Detach the clamp.
Detach the clamp.
Detach the hook.
Remove the 4 bolts.
|
Protective Tape |
Using a screwdriver, detach the guide and remove the separate type front seatback assembly.
Tape the screwdriver tip before use.
16.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
Pull out the 2 fasteners.
Detach the hook.
Open the 2 fasteners.
Pass the front seat side airbag harness and front No. 2 seat wire LH through the hole of the front seatback cover sub-assembly LH.
|
Remove in this Direction |
Detach the claw and remove the 2 front seat headrest supports as shown in the illustration.
Remove the separate type front seatback cover with pad.
71074A
17.REMOVE FRONT SEATBACK COVER SUB-ASSEMBLY LH
Using a thin-bladed screwdriver, detach the hook and remove the front seatback cover sub-assembly LH from the front seatback pad LH as shown in the illustration.
| *A | w/ Front Seat Side Airbag | *B | w/o Front Seat Side Airbag |
|
Protective Tape | - | - |
Be careful not to dirty or damage the front seatback cover sub-assembly LH.
Tape the thin-bladed screwdriver tip before use.
73920B
18.REMOVE FRONT SEAT AIRBAG ASSEMBLY LH (w/ Front Seat Side Airbag)
8219BA
19.REMOVE FRONT NO. 2 SEAT WIRE LH
Disconnect the connector.
Detach the clamp and remove the front No. 2 seat wire LH.
71053A
20.REMOVE FRONT SEATBACK SPRING SUB-ASSEMBLY LH
| *a | Clamp |
| *b | Guide |
|
Remove in this Direction |
Detach the clamp.
Detach the guide and remove the front seatback spring sub-assembly LH as shown in the illustration.
71587L
21.REMOVE FRONT SEATBACK EDGE PROTECTOR LH
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw and remove the 2 front seatback edge protectors LH.
Tape the thin-bladed screwdriver tip before use.
71759F
22.REMOVE FRONT SEATBACK HOOK LH
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw and remove the 2 front seatback hooks LH.
Do not reuse the removed front seatback hook LH.
Tape the thin-bladed screwdriver tip before use.
23.REMOVE SCREW GROMMET
Remove the 2 screw grommets.
24.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
Detach the hook and remove the separate type front seat cushion cover with pad.
71072
25.REMOVE FRONT SEAT CUSHION COVER SUB-ASSEMBLY LH
| *a | Band |
|
Remove in this Direction |
Detach the band as shown in the illustration.
Using a thin-bladed screwdriver, detach the hook and remove the front seat cushion cover sub-assembly LH from the front seat cushion pad LH as shown in the illustration.
|
Protective Tape | - | - |
Do not dirty or damage the front seat cushion cover sub-assembly LH.
Tape the thin-bladed screwdriver tip before use.
71H76B
26.REMOVE LH SEAT RECLINING ADJUSTER INSIDE COVER LH
|
Remove in this Direction |
Detach the claw and hook and remove the LH seat reclining adjuster inside cover LH as shown in the illustration.
71H76C
27.REMOVE LH SEAT RECLINING ADJUSTER INSIDE COVER RH
| *a | Guide |
| *b | Hook |
|
Remove in this Direction |
Detach the guide, claw and hook and remove the LH seat reclining adjuster inside cover RH as shown in the illustration.
71874V
28.REMOVE FRONT SEAT OUTER CUSHION SHIELD
| *a | Hook |
| *b | Guide |
|
Remove in this Direction |
|
Protective Tape |
Detach the hook.
Using a thin-bladed screwdriver, detach the claw as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
Pull in the removal direction shown in the illustration and detach the guide and remove the front seat outer cushion shield.
71874W
29.REMOVE FRONT SEAT INNER CUSHION SHIELD
| *a | Hook |
| *b | Guide |
|
Remove in this Direction |
|
Protective Tape |
Detach the hook.
Using a thin-bladed screwdriver, detach the claw as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
Pull in the removal direction shown in the illustration and detach the guide and remove the front seat inner cushion shield.
7181BA
30.REMOVE FRONT SEAT CUSHION WIRE HARNESS HOLDER LH
Disconnect the connector.
Detach the clamp.
| *A | w/ Seat Position Airbag Sensor |
Disconnect the 2 connectors.
w/ Seat Position Airbag Sensor:
Disconnect the connector.
Detach the clamp.
|
Remove in this Direction |
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
| *a | Guide |
| *b | Hook |
|
Remove in this Direction |
|
Protective Tape |
Remove the 2 screws.
Using a thin-bladed screwdriver, detach the claw.
Tape the thin-bladed screwdriver tip before use.
Pull in the removal direction shown in the illustration and detach the hook and guide and remove the front seat cushion wire harness holder LH.
Remove the front seat cushion wire harness holder LH together with the front No. 3 seat wire LH and front No. 4 seat wire LH.
82192A
31.REMOVE FRONT NO. 3 SEAT WIRE LH (w/ Seat Position Airbag Sensor)
|
Protective Tape |
Detach the clamp.
Using a thin-bladed screwdriver, detach the claw and remove the front No. 3 seat wire LH.
Tape the thin-bladed screwdriver tip before use.
82192B
32.REMOVE FRONT NO. 4 SEAT WIRE LH
Detach the claw and clamp and remove the front No. 4 seat wire LH.
71874U
33.REMOVE FRONT SEAT LOWER CUSHION SHIELD LH
|
Remove in this Direction |
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw.
Tape the thin-bladed screwdriver tip before use.
Detach the guide and remove the front seat lower cushion shield LH as shown in the illustration.