Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front power seat switch removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type C:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.REMOVE FRONT SEAT ASSEMBLY LH
71862K
3.REMOVE FRONT SEAT INNER CUSHION SHIELD LH
71812T
4.REMOVE FRONT SEAT CUSHION SHIELD LH
84921B
5.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
84921A
6.REMOVE RECLINING POWER SEAT SWITCH KNOB
84922
7.REMOVE FRONT POWER SEAT SWITCH
Remove the 2 screws.
Detach the guide and remove the seat adjuster shield clamp bracket LH.
Remove the 2 screws.
Detach the guide and remove the front power seat switch.