Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear seat assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
The procedure listed below is a representative example.
Use the same procedure for first row and second row, unless otherwise specified.
1. PRECAUTION (for First Row)
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type C:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
If the pretensioner has been deployed, replace any damaged parts as necessary.
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for First Row)
Operate the rear power seat switch and move the ottoman to the uppermost position and seatback to the frontmost position.
Disconnet the cable from the negative (-) battery terminal.
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
71940G
3.REMOVE NO. 1 SEAT HEADREST ASSEMBLY LH
Remove the No. 1 seat headrest assembly LH.
71H74
4.REMOVE REAR SEAT LOWER CUSHION SHIELD LH (for First Row)
|
Remove in this Direction |
Detach the claw and guide and remove the rear seat lower cushion shield LH as shown in the illustration.
79246H
5.REMOVE NO. 2 SEAT LEG COVER LH (for Second Row)
|
Remove in this Direction |
Detach the claw and guide and remove the No. 2 seat leg cover LH as shown in the illustration.
79246J
6.REMOVE NO. 3 SEAT LEG COVER LH (for Second Row)
|
Remove in this Direction |
Detach the claw and guide and remove the No. 3 seat leg cover LH as shown in the illustration.
7.REMOVE REAR SEAT ASSEMBLY LH
for First Row:
Disconnect the 2 connectors and detach the clamp.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector:
for Second Row:
Disconnect the connector.
|
Open in this Direction |
Using moulding remover A, detach the claw and open the cover as shown in the illustration.
Use the same procedure for all covers.
Remove the 2 bolts.
Remove the 2 bolts and rear seat assembly LH.
2 or more people are required when carrying the rear seat assembly LH out of the vehicle.
Do not damage the rear seat assembly LH, seat rail, body exterior or interior parts.
71397H
8.REMOVE REAR SEAT STOPPER LH (for First Row)
Perform this procedure when replacing the rear seat stopper LH.
|
Remove in this Direction |
Detach the guide and remove the rear seat stopper LH as shown in the illustration.