Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
86280
1.INSTALL STEREO COMPONENT AMPLIFIER ASSEMBLY
86285
2.INSTALL NO. 1 AMPLIFIER BRACKET
Install the No. 1 amplifier bracket with the 2 screws.
86286
3.INSTALL NO. 2 AMPLIFIER BRACKET
Install the No. 2 amplifier bracket with the 2 screws.
4.INSTALL STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET
Install the stereo component amplifier assembly with bracket with the 2 bolts.
Attach the wire harness clamp.
|
Connector |
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Connect the 2 connectors.
86183E
5.INSTALL AUDIO AMPLIFIER COVER
Install the audio amplifier cover with the 2 clips.
6.INSTALL FRONT SEAT ASSEMBLY RH
Use the same procedure described for the LH side.
for Power Seat:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>INSTALLATION
for Separate Seat Type:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Separate Seat Type)>INSTALLATION
for Sliding Bench Seat Type:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Sliding Bench Seat Type)>INSTALLATION
7. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
8. PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Front Seat Side Airbag)
9.CHECK SRS WARNING LIGHT (w/ Front Seat Side Airbag)
10.INSPECT SEAT BELT WARNING SYSTEM (w/ Front Seat Side Airbag)
11.INSPECT FRONT SEAT ASSEMBLY (for Power Seat)