Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
86150A
1.INSTALL NO. 2 SPEAKER ASSEMBLY WITH BRACKET (for 6 Speakers)
Attach the claw and guide to install the No. 2 speaker assembly with bracket.
| *A | for LH Side | *B | for RH Side |
Install the 2 screws.
Connect the connector.
| *A | for LH Side | *B | for RH Side |
|
Screw |
|
Connector |
86160Q
2.INSTALL ROOF SPEAKER ASSEMBLY (for 12 Speakers)
for Front Roof Side:
Attach the claw and guide to install the roof speaker assembly.
| *A | for LH Side | *B | for RH Side |
Install the 2 screws.
Connect the connector.
| *A | for LH Side | *B | for RH Side |
|
Screw |
|
Connector |
for Rear Roof Side:
Attach the claw and guide to install the roof speaker assembly.
| *A | for LH Side | *B | for RH Side |
Install the 2 screws.
Connect the connector.
| *A | for LH Side | *B | for RH Side |
|
Screw |
|
Connector |
3.INSTALL ROOF HEADLINING ASSEMBLY
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Airbag System)
for 7GR-FKS:
for 1GD-FTV:
5. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL (w/ Airbag System)
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
6. PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Airbag System)
7.CHECK SRS WARNING LIGHT (w/ Airbag System)
8.INSPECT SEAT BELT WARNING SYSTEM (w/ Seat Belt Warning System)