The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the inner rear view mirror assembly removal/installation are shown below.
76801
1.REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
except Wagon:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>BACK DOOR OUTSIDE GARNISH (except Wagon)>REMOVAL
867C0
2.REMOVE INNER MIRROR CAMERA ASSEMBLY
| *A | w/o Rear View Monitor System |
| *B | w/ Rear View Monitor System |
Disconnect the washer hose.
| *A | w/o Rear View Monitor System |
| *B | w/ Rear View Monitor System |
Disconnect each connector.
| *A | w/o Rear View Monitor System |
| *B | w/ Rear View Monitor System |
Remove the 2 screws.
w/o Rear View Monitor System:
|
Remove in this Direction |
Detach the claw and remove the inner mirror camera assembly with camera cleaner nozzle assembly from the back door panel as shown in the illustration.
|
Remove in this Direction |
Detach the claw and remove the camera cleaner nozzle assembly from the inner camera assembly as shown in the illustration.
w/ Rear View Monitor System:
|
Remove in this Direction |
Detach the claw and remove the inner mirror camera assembly with camera cleaner nozzle assembly from the back door panel as shown in the illustration.
|
Remove in this Direction |
Remove the 2 screws.
Detach the guide and remove the inner mirror camera assembly as shown in the illustration.