Home › Vehicle Interior › LIGHTING (INT) › SPOT LIGHT (for Wagon) › from 2019.06
RM35X0E _58 Vehicle Interior _078381 LIGHTING (INT) _0396484 SPOT LIGHT(for Wagon) A

LIGHTING (INT)  SPOT LIGHT(for Wagon)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RHD and LHD vehicles.

·

The procedure listed below is for the LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 81360T 1.INSTALL SPOT LIGHT ASSEMBLY (for Front Side)

a.
E417843

Attach the guide and claw to install the spot light assembly.


b.
E417892C01
0,0 0,0 false
V100135

Screw
V100136

Connector


Install the 2 screws.


c.

Connect the connector.


d.

w/ Rear Cooler:

i.
E421173

Install the air duct with hot-melt glue.



e.

w/ Rear Air Conditioning System:

i.
E421175

Install the air duct with hot-melt glue.


ii.
E421174

Install the air duct with hot-melt glue.



f.
B553099

Align the markings on the roof headlining assembly with the 2 silencer pads to install them using hot-melt glue as shown in the illustration.


Hide 867C1 3.INSTALL MIRROR CAMERA WIRE (w/ Digital Inner Mirror)

Hide 81360T 4.INSTALL SPOT LIGHT ASSEMBLY (for Rear Side)

a.
E417845

Attach the guide and claw to install the spot light assembly.


b.
E417844C01
0,0 0,0 false
V100135

Screw
V100136

Connector


Install the screw.


c.

Connect the connector.


Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Airbag System)

Hide 7. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL (w/ Airbag System)

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART


Hide 10.INSPECT SEAT BELT WARNING SYSTEM (w/ Seat Belt Warning System)