The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the spot light assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION (w/ Airbag System)
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type C:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Airbag System)
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
3.REMOVE ROOF HEADLINING
81360T
4.REMOVE SPOT LIGHT ASSEMBLY (for Rear Side)
|
Screw |
|
Connector |
Disconnect the connector.
Remove the screw.
Detach the claw and guide and remove the spot light assembly.
867C1
5.REMOVE MIRROR CAMERA WIRE (w/ Digital Inner Mirror)
6.REMOVE WASHER HOSE ASSEMBLY
81360T
7.REMOVE SPOT LIGHT ASSEMBLY (for Front Side)
Remove the 2 silencer pads.
w/ Rear Cooler:
Remove the air duct.
w/ Rear Air Conditioning System:
Remove the air duct.
Remove the air duct.
|
Screw |
|
Connector |
Disconnect the connector.
Remove the 2 screws.
Detach the claw and guide and remove the spot light assembly.