Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE › from 2019.06
RM35X0E _59 Vehicle Exterior _079322 EXTERIOR PANELS / TRIM _0397113 BLACK OUT TAPE A

EXTERIOR PANELS / TRIM  BLACK OUT TAPE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the black out tape removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
·

Outer rear view mirror assembly LH (Including removal and installation)

·

Outer rear view mirror assembly RH (Including removal and installation)


Side television camera view adjustment Panoramic view monitor system (Click here)
·

Front television camera assembly, radiator grille assembly or front bumper assembly

·

Television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


Television camera view adjustment (Adjustment of all cameras)
HINT:

Replacement or removal and installation of 2 or more parts


Panoramic view monitor system (Click here)
·

Front door glass sub-assembly LH

·

Front door glass sub-assembly RH

·

Front door glass run LH

·

Front door glass run RH


Initialize power window control system
·

Auto up and down function

·

Jam protection function

·

Catch protection function

·

Remote control function

·

Key-linked function

·

Wireless transmitter-linked function

·

Key-off operation function


(Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*: w/ Stop and start system

Stop and start system* Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). (Click here)
Lane control system Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power slide door system Fully close the slide door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the slide door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

Use the same procedure described for the LH side.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


b.

for 1GD-FTV:

Click hereGeneral>MAINTENANCE>1GD-FTV BATTERY>REMOVAL

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




Hide 69278B 2.REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH

Hide 3.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

Hide 4.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

Hide 67602 5.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 68172A 6.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

Hide 68195B 7.REMOVE FRONT DOOR REAR BELT SEAL LH

Hide 68193C 8.REMOVE FRONT DOOR FRONT BELT SEAL LH

Hide 75752C 9.REMOVE FRONT DOOR FRONT WINDOW FRAME MOULDING LH

Hide 87940 10.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

Hide 67832 11.REMOVE FRONT DOOR SERVICE HOLE COVER LH

Hide 67836C 12.REMOVE FRONT DOOR NO. 3 SERVICE HOLE COVER LH (w/ Curtain Shield Airbag)

Hide 67838F 13.REMOVE FRONT DOOR NO. 4 SERVICE HOLE COVER LH (w/ Curtain Shield Airbag)

Hide 68151D 14.DISCONNECT FRONT DOOR GLASS RUN LH

Hide 67402F 15.REMOVE FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY LH

Hide 68102 16.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 68151D 17.REMOVE FRONT DOOR GLASS RUN LH

Hide 68126 18.REMOVE FRONT DOOR FIX WINDOW GLASS LH

Hide 67862 19.REMOVE FRONT DOOR WEATHERSTRIP LH

a.
B537918C01
0,0 0,0 false
V100155

Protective Tape


Using a clip remover with its tip wrapped with protective tape, detach the clip.


b.

Using a screwdriver with its tip wrapped with protective tape, detach the clip and remove only the part of the front door weatherstrip LH shown in the illustration.

B553799C01
0,0 0,0 false
V100155

Protective Tape - -



Hide 75926A 20.REMOVE NO. 3 BLACK OUT TAPE LH

HINT:

When removing the No. 3 black out tape LH, if it is difficult to remove, heat the adhesive of the No. 3 black out tape LH and front door panel using a heat light.


Standard Value:
Part Temperature
Front Door Panel 40 to 60°C (104 to 140°F)
No. 3 Black Out Tape LH 40 to 60°C (104 to 140°F)


CAUTION:
E306500C35
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


·

Do not touch the heat light and heated parts.

·

Touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the front door panel and No. 3 black out tape LH excessively.


a.
B552905

Pull back on one of the ends of the No. 3 black out tape LH to remove it.

HINT:

When pulling on the No. 3 black out tape LH, pull it parallel to the front door panel.



Hide 75924B 21.REMOVE NO. 2 BLACK OUT TAPE LH

HINT:

When removing the No. 2 black out tape LH, if it is difficult to remove, heat the adhesive of the No. 2 black out tape LH and front door panel using a heat light.


Standard Value:
Part Temperature
Front Door Panel 40 to 60°C (104 to 140°F)
No. 2 Black Out Tape LH 40 to 60°C (104 to 140°F)


CAUTION:
E306500C35
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


·

Do not touch the heat light and heated parts.

·

Touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the front door panel and No. 2 black out tape LH excessively.


a.
B552906

Pull back on one of the ends of the No. 2 black out tape LH to remove it.

HINT:

When pulling on the No. 2 black out tape LH, pull it parallel to the front door panel.



Hide 75922M 22.REMOVE NO. 1 BLACK OUT TAPE LH

HINT:

When removing the No. 1 black out tape LH, if it is difficult to remove, heat the adhesive of the No. 1 black out tape LH and front door panel using a heat light.


Standard Value:
Part Temperature
Front Door Panel 40 to 60°C (104 to 140°F)
No. 1 Black Out Tape LH 40 to 60°C (104 to 140°F)


CAUTION:
E306500C35
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


·

Do not touch the heat light and heated parts.

·

Touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the front door panel and No. 1 black out tape LH excessively.


a.
B552907

Pull back on one of the ends of the No. 1 black out tape LH to remove it.

HINT:

When pulling on the No. 1 black out tape LH, pull it parallel to the front door panel.