Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
86792C
1.INSTALL PARKING ASSIST ECU
|
Nut |
|
Connector |
Install the parking assist ECU with the 2 nuts.
Connect the connector.
Connect the 4 connectors.
| *a | Lever Connector |
|
Rotate in this Direction |
Attach the claw to connect the lever connector.
Be sure to connect the connector securely.
88051B
2.INSTALL NO. 1 ION GENERATOR SUB-ASSEMBLY (w/ Ion Generator)
83100
3.INSTALL COMBINATION METER ASSEMBLY
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 7GR-FKS:
for 1GD-FTV:
5.INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
6.PERFORM DIAGNOSTIC SYSTEM CHECK
7.CHECK SRS WARNING LIGHT
8.PERFORM CALIBRATION