Home › Suspension › REAR SUSPENSION › REAR LOWER ARM › from 2019.06
RM35X0E _53 Suspension _078877 REAR SUSPENSION _0397335 REAR LOWER ARM A

REAR SUSPENSION  REAR LOWER ARM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the lower control arm assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced:
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Suspension, tires, etc. Television camera assembly optical axis (Back camera position setting) Parking assist monitor system (Click here)
·

Parking assist ECU initialization

·

Adjust steering angle


Panoramic view monitor system (Click here)
Perform headlight ECU sub-assembly LH initialization Lighting system (EXT)(w/ Headlight ECU) (Click here)


HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 48530 2.REMOVE REAR SHOCK ABSORBER ASSEMBLY

Hide 46430 3.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

Hide 48231B 4.REMOVE REAR COIL SPRING

Hide 48720 5.REMOVE LOWER CONTROL ARM ASSEMBLY

a.
C417369

Remove the nut, washer, bolt and lower control arm assembly from the vehicle body.


Hide 48258C 6.REMOVE REAR LOWER COIL SPRING INSULATOR