Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD) › from 2019.06
RM35X0E _54 Brake _078668 BRAKE SYSTEM (OTHER) _0381534 BRAKE PEDAL(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the brake pedal support assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). (Click here)
Lane control system Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power slide door system Fully close the slide door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the slide door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
B475753

Be sure to read Precaution thoroughly before servicing.



NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 73900 2.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 55646 3.REMOVE NO. 3 INSTRUMENT PANEL UNDER COVER

Hide 44610 5.REMOVE BRAKE BOOSTER ASSEMBLY

Hide 84340 6.REMOVE STOP LIGHT SWITCH ASSEMBLY

Hide 84345 7.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

Hide 8.REMOVE BRAKE PEDAL RETURN SPRING

a.
C410865

Remove the brake pedal return spring from the brake pedal support assembly.


Hide 47264A 9.REMOVE PUSH ROD PIN

a.
C410867

Remove the clip and push rod pin.


Hide 47110 10.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.
C417191

w/ Brake pedal Load Sensing Switch:

i.

Disconnect the connector from the brake pedal support assembly.



b.
C414022

Remove the 2 clips from the brake pedal support assembly.


c.
C410869

Remove the bolt and brake pedal support assembly from the instrument panel reinforcement assembly.


Hide 47121 11.REMOVE BRAKE PEDAL PAD