The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front door lock assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure below is for the LH side.
When removing the front door glass sub-assembly LH, move the front door glass sub-assembly LH to the lowest position before disconnecting the negative (-) battery terminal.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 7GR-FKS:
for 1GD-FTV:
Click hereGeneral>MAINTENANCE>1GD-FTV BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
69278B
3.REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH
4.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
67602
6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
68172A
7.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH
68195B
8.REMOVE FRONT DOOR REAR BELT SEAL LH
68193C
9.REMOVE FRONT DOOR FRONT BELT SEAL LH
86160
10.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY
67626A
11.REMOVE NO. 2 DOOR TRIM BRACKET
67832
12.REMOVE FRONT DOOR SERVICE HOLE COVER LH
67836C
13.REMOVE FRONT DOOR NO. 3 SERVICE HOLE COVER LH (w/ Curtain Shield Airbag)
67838F
14.REMOVE FRONT DOOR NO. 4 SERVICE HOLE COVER LH (w/ Curtain Shield Airbag)
68151D
15.DISCONNECT FRONT DOOR GLASS RUN LH
67402F
16.REMOVE FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY LH
68102
17.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
68151D
18.REMOVE FRONT DOOR GLASS RUN LH
67834
19.REMOVE FRONT DOOR NO. 2 SERVICE HOLE COVER LH
69820
20.REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY LH
67404F
21.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH
69220
22.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH (w/ Lock Cylinder)
23.REMOVE FRONT DOOR LOCK CYLINDER ASSEMBLY LH (w/ Lock Cylinder)
69312
24.REMOVE FRONT DOOR LOCK OPEN ROD LH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Remove in this Direction (3) |
Detach the snap in the direction (1) indicated by the arrow shown in the illustration and disconnect the front door lock open rod LH in the direction (2) indicated by the arrow shown in the illustration.
Remove the front door lock open rod LH in the direction (3) indicated by the arrow shown in the illustration.
69040A
25.REMOVE FRONT DOOR LOCK WITH MOTOR ASSEMBLY LH
|
"TORX" Screw |
|
Connector |
Disconnect the connector.
Using a T30 "TORX" socket wrench, remove the 3 "TORX" screws and front door lock with motor assembly LH.
69318C
26.REMOVE DOOR LOCK WIRING HARNESS SEAL
When reusing front door lock with motor assembly LH:
Remove the door lock wiring harness seal from the front door lock with motor assembly LH.
69036A
27.REMOVE FRONT DOOR LOCK COVER SUB-ASSEMBLY LH
|
Remove in this Direction |
|
Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, detach the claw and open the front door lock cover sub-assembly LH.
Detach the claw and remove the front door lock cover sub-assembly LH.
69720D
28.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
|
Remove in this Direction |
Detach the clamp and remove the front door lock remote control cable assembly LH as shown in the illustration.
69760B
29.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH
|
Remove in this Direction |
Detach the clamp and remove the front door inside locking cable assembly LH as shown in the illustration.