Use the same procedure for RHD and LHD vehicles.
The procedure below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
8598A
1.INSTALL DOOR CONTROL BATTERY
|
Nut |
|
Connector |
Connect the connector.
Install the door control battery with the 2 nuts.
Do not reuse the door control receiver that has been dropped.
2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 7GR-FKS:
for 1GD-FTV:
3. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
4.INSPECT SRS WARNING LIGHT
5. PERFORM DIAGNOSTIC SYSTEM CHECK