The skid control ECU (brake actuator assembly) sends signals such as brake request signals to the ECM. When the ECM detects logic error signals sent from the skid control ECU (brake actuator assembly) for a certain period of time, DTC P163181 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| P163181 | Communication Error from ECM to VSC Invalid Serial Data Received | When the engine switch on (IG) and the dynamic radar cruise control system is operating, the ECM detects logic error signals sent from the skid control ECU (brake actuator assembly) for approximately 1 second or more. | ·
Electronically controlled brake system ·
ECM |
Cruise Control |
Before replacing the ECM, refer to Service Bulletin.
Check for electronically controlled brake system DTCs.
| Result | Proceed to |
|---|---|
| Electronically controlled brake system DTCs are not output | A |
| Electronically controlled brake system DTCs are output | B |
A
B
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC P163181 is not output | A |
| DTC P163181 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
for 1GD-FTV: Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECM>REMOVAL
for 7GR-FKS: Click hereEngine / Hybrid System>7GR-FKS (ENGINE CONTROL)>ECM>REMOVAL