Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2019.06
RM35X0E _51 Engine / Hybrid System _078884 CRUISE CONTROL _0397572 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  U040181  Invalid Data Received from ECM/PCM "A" Invalid Serial Data Received  


DESCRIPTION

If the ECM cannot recognize the forward recognition camera. DTC U040181 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
U040181 Invalid Data Received from ECM/PCM "A" Invalid Serial Data Received When the engine switch on (IG) for 17 seconds or more, the ECM cannot recognize the forward recognition camera continues for 2 second or more. ECM Radar Cruise2

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the ECM, refer to Service Bulletin.


PROCEDURE

1.CHECK FOR DTCs (Radar Cruise2)
a.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Radar Cruise2 > Clear DTCs
50002 426

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



c.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Radar Cruise2 > Trouble Codes
50001 426

Result:
Result Proceed to
DTC U040181 is not output A
DTC U040181 is output B



A

B