The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the No. 2 and No. 3 parking brake cable assemblies removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
17420
2.REMOVE CENTER EXHAUST PIPE ASSEMBLY (for 7GR-FKS)
17420
3.REMOVE CENTER EXHAUST PIPE ASSEMBLY (for 1GD-FTV)
4.REMOVE UPPER MAIN MUFFLER HEAT INSULATOR
5.REMOVE NO. 3 FLOOR HEAT INSULATOR
58328B
6.REMOVE LOWER MAIN MUFFLER HEAT INSULATOR
for Standard Roof:
Remove the 3 bolts and lower main muffler heat insulator.
for High Roof:
Remove the 5 bolts and lower main muffler heat insulator.
46410
7.SEPARATE NO. 1 PARKING BRAKE CABLE ASSEMBLY
46301
8.REMOVE PARKING BRAKE INTERMEDIATE LEVER SUB-ASSEMBLY
Remove the parking brake intermediate lever tension spring.
| *1 | No. 2 Parking Brake Cable Assembly |
| *2 | No. 3 Parking Brake Cable Assembly |
Remove the 2 bolts and separate the No. 2 and No. 3 parking brake cable assemblies.
| *1 | No. 2 Parking Brake Cable Assembly |
| *2 | No. 3 Parking Brake Cable Assembly |
| *a | End of No. 2 Parking Brake Cable Assembly |
| *b | End of No. 3 Parking Brake Cable Assembly |
Disconnect the end of the No. 2 and No. 3 parking brake cable assemblies and separate the No. 2 and No. 3 parking brake cable assemblies from the parking brake intermediate lever sub-assembly.
Remove the 2 bolts and parking brake intermediate lever sub-assembly
46430
9.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY (for Rear Drum Brake)
46430
10.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY (for Rear Disc Brake)
46420
11.SEPARATE NO. 2 PARKING BRAKE CABLE ASSEMBLY
Use the same procedure as for the No. 3 parking brake cable assembly.
46430
12.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY (for Rear Drum Brake)
46430
13.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY (for Rear Disc Brake)
46420
14.DISCONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY
Use the same procedure as for the No. 3 parking brake cable assembly.
46430
15.REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY (for High Roof)
Remove the 2 bolts and separate the No. 3 parking brake cable assembly from the rear leaf spring assembly.
Remove the 4 bolts and No. 3 parking brake cable assembly from the vehicle body.
46430
16.REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY (for Standard Roof)
for Wagon:
Remove the bolt and separate the No. 3 parking brake cable assembly from the lower control arm assembly.
except Wagon:
Remove the 2 bolts and separate the No. 3 parking brake cable assembly from the rear leaf spring assembly.
for Wagon:
Remove the 3 bolts and No. 3 parking brake cable assembly from the vehicle body.
except Wagon:
Remove the 3 bolts and No. 3 parking brake cable assembly from the vehicle body.
46420
17.REMOVE NO. 2 PARKING BRAKE CABLE ASSEMBLY (for High Roof)
Remove the bolt and separate the No. 2 parking brake cable assembly from the rear leaf spring assembly.
Remove the 3 bolts and No. 2 parking brake cable assembly from the vehicle body.
46420
18.REMOVE NO. 2 PARKING BRAKE CABLE ASSEMBLY (for Standard Roof)
for Wagon:
Remove the bolt and separate the No. 2 parking brake cable assembly from the lower control arm assembly.
except Wagon:
Remove the bolt and separate the No. 2 parking brake cable assembly from the rear leaf spring assembly.
for Wagon:
Remove the 2 bolts and No. 2 parking brake cable assembly from the vehicle body.
except Wagon:
Remove the 2 bolts and No. 2 parking brake cable assembly from the vehicle body.