The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the No. 1 parking brake cable assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
for Type C:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
46201E
2.REMOVE PARKING BRAKE LEVER SUB-ASSEMBLY
17420
3.REMOVE CENTER EXHAUST PIPE ASSEMBLY (for 7GR-FKS)
17420
4.REMOVE CENTER EXHAUST PIPE ASSEMBLY (for 1GD-FTV)
5.REMOVE UPPER MAIN MUFFLER HEAT INSULATOR
Remove the 5 bolts and upper main muffler heat insulator.
6.REMOVE NO. 3 FLOOR HEAT INSULATOR
Remove the 3 bolts, nut and No. 3 floor heat insulator.
46410
7.SEPARATE NO. 1 PARKING BRAKE CABLE ASSEMBLY
| *a | End of No. 1 Parking Brake Cable Assembly |
Remove the clip and disconnect the end of the No. 1 parking brake cable assembly.
Separate the No. 1 parking brake cable assembly from the parking brake intermediate lever assembly.
46410
8.REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY
Remove the bolt and No. 1 parking brake cable assembly from the vehicle body.
46420A
9.REMOVE NO. 1 PARKING BRAKE CABLE CLAMP
Remove the No. 1 parking brake cable clamp in the direction indicated by the arrow shown in the illustration.