Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1.INSPECT REAR SEAT OUTER BELT ASSEMBLY
73015A
2.INSTALL OUTER BELT ANCHOR BRACKET SUB-ASSEMBLY RH (for 60/40 Split Seat Type RH Side)
Attach the guide and install the outer belt anchor bracket sub-assembly RH with the bolt.
73570A
3.INSTALL NO. 3 SEAT OUTER BELT ASSEMBLY LH
Attach the guide.
Temporarily install the No. 3 seat outer belt assembly LH with the 2 bolts.
Tighten the 2 bolts in the order shown in the illustration.
Install the bolt.
|
Close in this Direction |
Attach the claw and close the cover as shown in the illustration.
62520B
4.INSTALL QUARTER TRIM PANEL ASSEMBLY LH
67872A
5.INSTALL NO. 1 SLIDE DOOR WEATHERSTRIP LH
Use the same procedure described for the RH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR OPENING TRIM WEATHERSTRIP (for Wagon)>INSTALLATION
73570A
6.INSTALL NO. 3 SEAT OUTER BELT ASSEMBLY LH
Install the floor anchor of the No. 3 seat outer belt assembly LH with the bolt.
Check that the ELR locks.
With the No. 3 seat outer belt assembly LH installed to the vehicle, check that the belt locks when it is pulled out quickly.
73233
7.INSTALL OUTER LAP BELT ANCHOR COVER
| *a | Guide A |
| *b | Guide B |
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Attach the guide B in the installation direction (1) shown in the illustration.
Attach the guide A in the installation direction (2) shown in the illustration and install the outer lap belt anchor cover.
67935
8.INSTALL BACK DOOR SCUFF PLATE
9.INSTALL REAR SEAT ASSEMBLY
for Folding Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Folding Type)>INSTALLATION
for 60/40 Split Seat Type 40 Side:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for 60/40 Split Seat Type 40 Side)>INSTALLATION
for 60/40 Split Seat Type 60 Side:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for 60/40 Split Seat Type 60 Side)>INSTALLATION
for Manual Captain Seat:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Manual Captain Seat)>INSTALLATION
for Power Captain Seat:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Power Captain Seat)>INSTALLATION
10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for First Row)
for 7GR-FKS:
for 1GD-FTV:
11. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL (for First Row)
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
12. PERFORM DIAGNOSTIC SYSTEM CHECK (for First Row)
13.CHECK SRS WARNING LIGHT (for First Row)
14.INSPECT SEAT BELT WARNING SYSTEM
15.INSPECT REAR SEAT ASSEMBLY
16.INSPECT SEAT HEATER SYSTEM (w/ Seat Heater System)