The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during room light switch removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION (for Full-trim, w/ Knee Airbag)
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
for Type C:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for Full-trim, w/ Knee Airbag)
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
55631A
3.REMOVE NO. 1 INSTRUMENT PANEL UNDER TRAY STOPPER
55011A
4.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55044C
5.REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
55404E
6.REMOVE UPPER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
33622
7.DISCONNECT NO. 1 SHIFT LEVER KNOB COVER (for Automatic Transmission)
33504F
8.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
for Manual Transmission:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
for Automatic Transmission:
Click hereDrivetrain>AC60E (AUTOMATIC TRANSMISSION / TRANSAXLE)>SHIFT LEVER KNOB>REMOVAL
58840Q
9.REMOVE SHIFTING HOLE COVER ASSEMBLY (for Manual Transmission)
35970F
10.REMOVE POSITION INDICATOR HOUSING ASSEMBLY (for Automatic Transmission)
55405B
11.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System)
55900
12.REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)
55414A
13.REMOVE INSTRUMENT CLUSTER FINISH PANEL END (for Semi-trim)
67912A
14.REMOVE FRONT DOOR OUTSIDE SCUFF PLATE LH (for Full-trim)
67914B
15.REMOVE FRONT DOOR SCUFF PLATE LH (for Full-trim)
62112
16.REMOVE COWL SIDE TRIM BOARD LH (for Full-trim)
55318C
17.REMOVE INSTRUMENT SIDE PANEL LH (for Full-trim)
55641
18.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER (for Full-trim)
53601
19.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (for Full-trim)
77306
20.REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY (for Full-trim)
55432D
21.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL (for Full-trim)
55433B
22.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (for Full-trim)
55445B
23.REMOVE INSTRUMENT PANEL FINISH PLATE (for Full-trim, w/o Knee Airbag)
55313
24.REMOVE LOWER INSTRUMENT PANEL LH (for Full-trim, w/o Knee Airbag)
73900
25.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Full-trim, w/ Knee Airbag)
67911B
26.REMOVE FRONT DOOR OUTSIDE SCUFF PLATE RH (for Full-trim)
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL
67913B
27.REMOVE FRONT DOOR SCUFF PLATE RH (for Full-trim)
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL
62111C
28.REMOVE COWL SIDE TRIM BOARD RH (for Full-trim)
55632B
29.REMOVE NO. 2 INSTRUMENT PANEL UNDER TRAY SUPPORT (for Full-trim)
55012A
30.REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY (for Full-trim)
55317A
31.REMOVE INSTRUMENT SIDE PANEL RH (for Full-trim)
55642
32.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER (for Full-trim)
55312
33.REMOVE LOWER INSTRUMENT PANEL (for Full-trim)
55438A
34.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL RETAINER (for Full-trim)
35.REMOVE FRONT CONSOLE BOX (for Full-trim, w/ Console Tray)
58533C
36.REMOVE CENTER FLOOR CARPET COVER RH (for Full-trim)
58534E
37.REMOVE CENTER FLOOR CARPET COVER LH (for Full-trim)
55646
38.REMOVE NO. 3 INSTRUMENT PANEL UNDER COVER (for Full-trim)
55434B
39.REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL (for Full-trim)
55320
40.REMOVE LOWER NO. 2 INSTRUMENT PANEL ASSEMBLY (for Full-trim)
55413D
41.REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL (for Full-trim)
55410C
42.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
55670
43.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
55447C
44.REMOVE NO. 2 SWITCH HOLE BASE
84172
45.REMOVE ROOM LIGHT SWITCH
|
Remove in this Direction |
Detach the claw and remove the room light switch as shown in the illustration.
84170B
46.REMOVE NO. 2 ROOM LIGHT SWITCH ASSEMBLY (for Wagon, w/ Rear Sunshade)
|
Remove in this Direction |
Detach the claw and remove the No. 2 room light switch assembly as shown in the illustration.