Home › Vehicle Interior › SEAT › POWER SEAT SWITCH (for Front Seat) › from 2019.06
RM35X0E _58 Vehicle Interior _078601 SEAT _0398433 POWER SEAT SWITCH(for Front Seat) A

SEAT  POWER SEAT SWITCH(for Front Seat)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 84922 1.INSTALL FRONT POWER SEAT SWITCH

a.
B552183N01
1.302,0.104 1.563,0.323 0.26,0.219 10 true (1) 2.76,0.302 2.979,0.51 0.219,0.208 10 true (3) 1.073,1.729 1.292,1.938 0.219,0.208 10 true (4) 2.24,1.677 2.458,1.885 0.219,0.208 10 true (2)

Attach the guide and set the front power seat switch and seat adjuster shield clamp bracket LH on the front seat cushion shield LH.


b.

Temporarily install the 4 screws.


c.

Tighten the 4 screws in the order shown in the illustration.

HINT:

When tightening, do not apply any other force than the tightening direction.



Hide 84921A 2.INSTALL RECLINING POWER SEAT SWITCH KNOB

Hide 84921B 3.INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

Hide 71812T 4.INSTALL FRONT SEAT CUSHION SHIELD LH

Hide 71862K 5.INSTALL FRONT SEAT INNER CUSHION SHIELD LH

Hide 7. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART


Hide 10.INSPECT SEAT BELT WARNING SYSTEM