Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear seat inner belt assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
The procedure listed below is a representative example.
Use the same procedure for first row and second row, unless otherwise specified.
1. PRECAUTION (for First Row)
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type C:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
If the pretensioner has been deployed, replace any damaged parts as necessary.
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for First Row)
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
3.REMOVE REAR SEAT ASSEMBLY LH
71849K
4.REMOVE SEAT SIDE TABLE ADJUSTER COVER CAP (for First Row, RH Side)
78060C
5.REMOVE NO. 1 SEAT SIDE TABLE ASSEMBLY (for First Row, RH Side)
71826A
6.REMOVE NO. 1 SEAT INNER CUSHION MOULDING RH
73380D
7.REMOVE REAR SEAT INNER BELT ASSEMBLY
for First Row:
Disconnect the connector and detach the clamp.
for Second Row:
w/o Power Supply Unit:
Disconnect the connector and detach the clamp.
w/ Power Supply Unit:
Disconnect the connector and detach the claw and clamp.
Remove the bolt and rear seat inner belt assembly.