Home › Vehicle Interior › SEAT BELT › REAR SEAT INNER BELT ASSEMBLY (for Manual Captain Seat) › from 2019.06
RM35X0E _58 Vehicle Interior _078602 SEAT BELT _0398435 REAR SEAT INNER BELT ASSEMBLY(for Manual Captain Seat) A

SEAT BELT  REAR SEAT INNER BELT ASSEMBLY(for Manual Captain Seat)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedures listed below are for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

The procedure listed below is a representative example.

·

Use the same procedure for first row and second row, unless otherwise specified.



PROCEDURE

Hide 73380D 1.INSTALL REAR SEAT INNER BELT ASSEMBLY

a.
B562788C01
0.823,2 1.292,2 true 1.688,2.198 2.156,2.198 true 0.646,1.885 0.823,2.083 0.177,0.198 10 true *a 2.156,2.083 2.333,2.281 0.177,0.198 10 true *a
*a Protruding Part


Install the rear seat inner belt assembly with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)

NOTICE:

Do not allow the anchor part of the rear seat inner belt assembly to overlap the protruding part.



b.

for First Row:

i.
B562784

Connect the connector and attach the clamp.



c.

for Second Row:

i.
B562785

w/o Power Supply Unit:

Connect the connector and attach the clamp.


ii.
B562786

w/ Power Supply Unit:

Connect the connector and attach the claw and clamp.



Hide 71826A 2.INSTALL NO. 1 SEAT INNER CUSHION MOULDING RH

Hide 78060C 3.INSTALL NO. 1 SEAT SIDE TABLE ASSEMBLY (for First Row, RH Side)

Hide 71849K 4.INSTALL SEAT SIDE TABLE ADJUSTER COVER CAP (for First Row, RH Side)

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for First Row)

Hide 7. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL (for First Row)

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART


Hide 10.INSPECT SEAT BELT WARNING SYSTEM