Home › Vehicle Interior › LIGHTING (INT) › REAR DOOR COURTESY SWITCH › from 2019.06
RM35X0E _58 Vehicle Interior _078381 LIGHTING (INT) _0381157 REAR DOOR COURTESY SWITCH A

LIGHTING (INT)  REAR DOOR COURTESY SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RHD and LHD vehicles.

·

The procedure listed below is for the LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the RH side.



PROCEDURE

Hide 84234 1.REMOVE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY

a.

for Semi-trim:

i.
E404936

Using a T30 "TORX" socket wrench, remove the "TORX" screw and rear door courtesy light switch assembly.


ii.
E404937

Disconnect the connector.



b.

for Full-trim:

i.
E404939

Using a T30 "TORX" socket wrench, remove the "TORX" screw and rear door courtesy light switch assembly.


ii.
E404940

Disconnect the connector.



Hide 2.REMOVE REAR SEAT ASSEMBLY

HINT:

Perform this procedure only when replacing the courtesy light wire.


·

for Commuter, 3-Passenger Seat with 2-Point Type Seat Belt and Headrest:

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Commuter, 3-Passenger Seat with 2-Point Type Seat Belt and Headrest)>REMOVAL

·

for Commuter, 3-Passenger Seat with 2-Point Type Seat Belt without Headrest:

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Commuter, 3-Passenger Seat with 2-Point Type Seat Belt without Headrest)>REMOVAL

·
·

for Commuter, Single-Passenger Seat with 2-Point Type Seat Belt:

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Commuter, Single-Passenger Seat with 2-Point Type Seat Belt)>REMOVAL

·

for Commuter, Single-Passenger Seat with 3-Point Type Seat Belt:

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Commuter, Single-Passenger Seat with 3-Point Type Seat Belt)>REMOVAL

·
·

for Commuter, 2-Passenger Seat with 2-Point Type Seat Belt and Headrest:

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Commuter, 2-Passenger Seat with 2-Point Type Seat Belt and Headrest)>REMOVAL

·

for Commuter, 2-Passenger Seat with 2-Point Type Seat Belt without Headrest:

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Commuter, 2-Passenger Seat with 2-Point Type Seat Belt without Headrest)>REMOVAL


Hide 3.REMOVE REAR SEAT OUTER BELT ASSEMBLY RH (FLOOR ANCHOR) (for Full-trim)

HINT:
·

Perform this procedure only when replacing the courtesy light wire.

·

Use the same procedure described for the LH side.

Click hereVehicle Interior>SEAT BELT>REAR SEAT OUTER BELT ASSEMBLY (for Full-trim)>REMOVAL



Hide 4.REMOVE REAR SEAT OUTER BELT ASSEMBLY RH (for Van)

HINT:
·

Perform this procedure only when replacing the courtesy light wire.

·

Use the same procedure described for the LH side.

Click hereVehicle Interior>SEAT BELT>REAR SEAT OUTER BELT ASSEMBLY (for Van)>REMOVAL



Hide 67935 5.REMOVE BACK DOOR SCUFF PLATE (for Full-trim)

HINT:

Perform this procedure only when replacing the courtesy light wire.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL


Hide 74733 6.REMOVE NO. 1 HAND GRIP COVER (w/ Hand Rail)

HINT:
·

Perform this procedure only when replacing the courtesy light wire.



Hide 74708 7.REMOVE NO. 2 HAND GRIP FRAME SUB-ASSEMBLY (w/ Hand Rail)

HINT:
·

Perform this procedure only when replacing the courtesy light wire.



Hide 8.REMOVE REAR DOOR SCUFF PLATE RH (for Full-trim)

HINT:

Perform this procedure only when replacing the courtesy light wire.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL


Hide 74617A 9.REMOVE ASSIST GRIP PLUG (for Full-trim, w/ Assist Grip)

HINT:

Perform this procedure only when replacing the courtesy light wire.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL


Hide 74680 10.REMOVE PILLAR ASSIST GRIP ASSEMBLY C (for Full-trim, w/ Assist Grip)

HINT:

Perform this procedure only when replacing the courtesy light wire.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL


Hide 62631D 11.REMOVE REAR QUARTER TRIM BOARD RH (for Semi-trim)

HINT:
·

Perform this procedure only when replacing the courtesy light wire.

·

Use the same procedure described for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>SIDE PANEL>REMOVAL



Hide 62630L 12.REMOVE REAR QUARTER TRIM BOARD ASSEMBLY RH (for Full-trim)

HINT:

Perform this procedure only when replacing the courtesy light wire.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL


Hide 62610K 13.REMOVE SIDE TRIM BOARD ASSEMBLY RH (for Full-trim, High Roof)

HINT:

Perform this procedure only when replacing the courtesy light wire.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL


Hide 82351B 14.REMOVE COURTESY LIGHT WIRE

HINT:

Perform this procedure only when replacing the courtesy light wire.


a.
E404938

Disconnect the 2 connectors and remove the courtesy light wire.