Home › Engine / Hybrid System › 1GD-FTV (EMISSION CONTROL) › EXHAUST GAS TEMPERATURE SENSOR (for EGR) › 2019.06–2021.07
RM35X0E _51 Engine / Hybrid System _079220 1GD-FTV EMISSION CONTROL _0398451 EXHAUST GAS TEMPERATURE SENSOR(for EGR) A

1GD-FTV EMISSION CONTROL  EXHAUST GAS TEMPERATURE SENSOR(for EGR)  INSTALLATION  


PROCEDURE

Hide 89425D 1.INSTALL NO. 5 EXHAUST GAS TEMPERATURE SENSOR

a.
A329093C01
1.667,0.573 1.979,0.729 0.313,0.156 10 false *a
*a Torque Wrench Fulcrum Length


Using a 14 mm union nut wrench, install the No. 5 exhaust gas temperature sensor to the No. 2 EGR pipe.

Torque:

Specified tightening torque

30 N*m {306 kgf*cm, 22 ft.*lbf}


NOTICE:

If the No. 5 exhaust gas temperature sensor is dropped, replace the new one.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When using a union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 26.3 N*m (268 kgf*cm, 19 ft.*lbf)




b.

Attach the clamp and connect the No. 5 exhaust gas temperature sensor to the No. 2 engine cover bracket.


c.

Connect the connector to the No. 5 exhaust gas temperature sensor.


Hide 12601B 2.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Cover)