Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › DIESEL THROTTLE BODY › 2019.02–2020.05
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0387389 DIESEL THROTTLE BODY A

1GD-FTV ENGINE CONTROL  DIESEL THROTTLE BODY  INSTALLATION  


PROCEDURE

Hide 26100G 1.INSTALL DIESEL THROTTLE BODY ASSEMBLY

a.
A443553

Connect the connector to install the emission control valve wire to the diesel throttle body assembly.


b.
A443552

Install new 2 gaskets and the diesel throttle body assembly and intake air connector with the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
A444939C01
1.479,0.76 0.917,0.198 0.917,0.198 2.823,0.292 true 0.719,0.083 1.031,0.24 0.313,0.156 10 false *a
*a Claw


The claws of the 2 gaskets must face the diesel throttle body assembly side shown in the illustration.



c.

Connect the connector and clamp.


d.
A443551

for Cold Area Specification Vehicles:

Connect the No. 11 water by-pass hose and No. 14 water by-pass hose to the diesel throttle body assembly, and slide the 2 clips to secure the hose.


e.
A443550

Connect the fuel hose bracket with the bolt to the diesel throttle body assembly.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


f.
A443560

Connect the intake air temperature sensor connector.


Hide 17303T 2.INSTALL AIR PIPE SUB-ASSEMBLY

Hide 25761B 3.INSTALL NO. 1 VACUUM TRANSMITTING HOSE

Hide 51405A 4.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 52618 5.INSTALL LOWER FRONT BUMPER ABSORBER

Hide 51406A 6.INSTALL NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)

Hide 12601B 7.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

a.
A443253

Attach the 2 clips and install the No. 1 engine cover sub-assembly to the No. 2 water by-pass pipe.


b.

Install the No. 1 engine cover sub-assembly to the No. 1 engine cover bracket and No. 2 engine cover bracket with the 2 nuts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)