Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
84319
1.INSTALL STEERING WHEEL SWITCH HOUSING
If reusing the steering wheel switch housing:
Using pliers, support the band clamp while loosened and set the steering wheel switch housing.
|
Install in this Direction |
Push the steering wheel switch housing forward to attach the claw to install it.
Tighten the band clamp.
If installing a new steering wheel switch housing:
Set the steering wheel switch in place.
|
Install in this Direction |
Push the steering wheel switch housing forward to attach the claw to install it.
|
Remove in this Direction |
Remove the pin to tighten the band clamp.
84329
2.INSTALL TURN SIGNAL SWITCH
84650
3.INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
4.INSTALL SPIRAL CABLE
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 7GR-FKS:
for 1GD-FTV:
6. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
7.PERFORM DIAGNOSTIC SYSTEM CHECK
8.CHECK SRS WARNING LIGHT
9.PERFORM SYSTEM INITIALIZATION AND CALIBRATION