Home › Engine / Hybrid System › 1GD-FTV (STARTING) › STARTER (for 2.0 kW Type) › from 2019.06
RM35X0E _51 Engine / Hybrid System _078666 1GD-FTV STARTING _0382050 STARTER(for 2.0 kW Type) A

1GD-FTV STARTING  STARTER(for 2.0 kW Type)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative when not Performed Necessary Procedures Link
Lane control system Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative when not Performed Necessary Procedures Link
Power slide door system Fully close the slide door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the slide door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 51406A 3.REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)

Hide 52618 4.REMOVE LOWER FRONT BUMPER ABSORBER

Hide 51405A 5.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 28100 6.REMOVE STARTER ASSEMBLY

a.

Open the starter terminal cap.


b.
A437458

Remove the nut and disconnect the starter wire.


c.

Disconnect the starter assembly connector.


d.
A437459

for Automatic Transmission:

Remove the nut, 2 bolts and starter assembly.


e.

for Manual Transmission:

i.
A437502

Remove the 2 nuts and disconnect the wire harness clamp bracket from the clutch release cylinder assembly.


ii.
A437496

Remove the 2 bolts and disconnect the clutch release cylinder assembly.


iii.
A437460

Remove the 2 bolts and starter assembly and disconnect the clutch flexible hose bracket.