Home › Engine / Hybrid System › 1GD-FTV (STARTING) › STARTER (w/ Stop And Start System) › from 2019.06
RM35X0E _51 Engine / Hybrid System _078666 1GD-FTV STARTING _0382052 STARTER(w/ Stop And Start System) A

1GD-FTV STARTING  STARTER(w/ Stop And Start System)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
Replacement of starter assembly
NOTICE:

When the starter assembly is replaced, "STARTER relay" and "STARTER NO.2 relay" must be also replaced.


Clear the number of starter operations Stop and start system (Click here)

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative when not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). (Click here)
Lane control system Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative when not Performed Necessary Procedures Link
Power slide door system Fully close the slide door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the slide door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY

·

When the starter assembly is replaced, "STARTER relay" and "STARTER NO. 2 relay" must be also replaced.



Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 51406A 3.REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 52618 4.REMOVE LOWER FRONT BUMPER ABSORBER

Hide 51405A 5.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 51495 6.REMOVE TRANSMISSION UNDER COVER (w/ Transmission Under Cover)

Hide 51408B 7.REMOVE ENGINE UNDER COVER SUB-ASSEMBLY RH (w/ Engine Under Cover Sub-assembly RH)

Hide 28100 8.REMOVE STARTER ASSEMBLY

NOTICE:

When the starter assembly is replaced, "STARTER relay" and "STARTER NO. 2 relay" must be also replaced.


a.
A437470

Open the starter terminal cap.


b.

Remove the nut and disconnect the starter wire.


c.

Detach the clamp and disconnect the 2 starter assembly connectors.


d.

for Automatic Transmission:

i.
A437471

Remove the nut, 2 bolts and starter assembly.



e.

for Manual Transmission:

i.
A437502

Remove the 2 nuts and disconnect the wire harness clamp bracket from the clutch release cylinder assembly.


ii.
A437496

Remove the 2 bolts and disconnect the clutch release cylinder assembly.


iii.
A437472

Remove the 2 bolts and starter assembly and disconnect the clutch flexible hose bracket.