The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during steering wheel assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
for Type A: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type B: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
for Type C: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 7GR-FKS: Click hereGeneral>MAINTENANCE>7GR-FKS BATTERY>REMOVAL
for 1GD-FTV: Click hereGeneral>MAINTENANCE>1GD-FTV BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
45130
4.REMOVE HORN BUTTON ASSEMBLY
84250A
5.REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)
45116
6.REMOVE NO. 1 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)
Use the same procedure described for the steering pad switch assembly.
45100
7.REMOVE STEERING WHEEL ASSEMBLY
Remove the steering wheel set bolt.
| *a | Matchmark |
Put matchmarks on the steering wheel and steering main shaft.
| *a | Hold |
| *b | Turn |
Using SST, remove the steering wheel assembly.
Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.
45184
8.REMOVE LOWER STEERING WHEEL BOSS COVER
Remove the 3 screws.
Remove the lower steering wheel boss cover from the steering wheel assembly.
864A2
9.REMOVE STEERING VIBRATION ECU (w/ Lane Departure Alert System)