Home › Drivetrain › RC60J (MANUAL TRANSMISSION / TRANSAXLE) › INTELLIGENT MANUAL TRANSMISSION SWITCH › from 2019.06
RM35X0E _52 Drivetrain _078740 RC60J MANUAL TRANSMISSION / TRANSAXLE _0382062 INTELLIGENT MANUAL TRANSMISSION SWITCH A

RC60J MANUAL TRANSMISSION / TRANSAXLE  INTELLIGENT MANUAL TRANSMISSION SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during pattern select switch assembly (intelligent manual transmission switch) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedures not Performed Link
Disconnect cable from negative(-) battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*: w/ Stop and start system

Stop and start system* Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). (Click here)
Lane control system Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more. (Click here)
Pre-collision system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power slide door system Fully close the slide door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the slide door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 55405B 1.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 55404E 2.REMOVE UPPER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 55447C 3.REMOVE NO. 2 SWITCH HOLE BASE

Hide 84720J 4.REMOVE PATTERN SELECT SWITCH ASSEMBLY (INTELLIGENT MANUAL TRANSMISSION SWITCH)

a.
C407242

Detach the 2 claws and remove the pattern select switch assembly (intelligent manual transmission switch) from the No. 2 switch hole base.