Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seat assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION (w/ Front Seat Side Airbag)
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
for Type C:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
If the front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.
Replace any other damaged parts as necessary.
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)
for 7GR-FKS:
for 1GD-FTV:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
71910F
3.REMOVE FRONT SEAT HEADREST ASSEMBLY LH
Remove the front seat headrest assembly LH.
71139U
4.REMOVE FRONT SEAT REAR LEG COVER LH
|
Place Hands Here |
|
Remove in this Direction |
Place your hands at the position and pull in the removal direction shown in the illustration and detach the claw and clip and remove the front seat rear leg cover LH.
5.REMOVE FRONT SEAT ASSEMBLY LH
w/ Front Seat Side Airbag:
Disconnect the front seat airbag assembly LH connector under the front seat assembly LH.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Disconnect each connector under the front seat assembly LH.
Operate the seat track adjusting handle LH to move the front seat assembly LH to the rearmost position.
Remove the 2 bolts.
Operate the seat track adjusting handle LH and move the front seat assembly LH to the frontmost position.
Remove the 2 bolts.
Operate the reclining adjuster release handle LH and move the seatback to the upright position.
Operate the seat track adjusting handle LH and move the front seat assembly LH to the center position.
Remove the front seat assembly LH.
2 or more people are required when carrying the front seat assembly LH out of the vehicle.
Protect the front seat legs.
Be careful not to damage the front seat assembly LH, body exterior or interior parts.