Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
71511A
1.INSTALL FRONT SEAT CUSHION PAD RH (OCCUPANT DETECTION SENSOR)
When installing the front seat cushion cover sub-assembly RH, refer to the Precaution section in order to prevent wrinkles from forming.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Separate Seat Type)>PRECAUTION
Attach the hook and install the front seat cushion cover sub-assembly RH to the front seat cushion pad RH (occupant detection sensor).
Be careful not to damage the front seat cushion cover sub-assembly RH.
| *a | Band |
|
Install in this Direction |
Attach the band.
2.INSTALL FRONT SEAT CUSHION COVER WITH PAD
Attach the hook and install the front seat cushion cover with pad.
Attach the hook.
Attach the claw.
3.INSTALL FRONT SEATBACK ASSEMBLY
71861K
4.INSTALL FRONT SEAT INNER CUSHION SHIELD RH
71811T
5.INSTALL FRONT SEAT CUSHION SHIELD RH
72525M
6.INSTALL RECLINING ADJUSTER RELEASE HANDLE RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Separate Seat Type)>REASSEMBLY
72551K
7.INSTALL RECLINING HINGE COVER RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Separate Seat Type)>REASSEMBLY
71130B
8.INSTALL FRONT SEAT LEG ASSEMBLY RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Separate Seat Type)>REASSEMBLY
71139M
9.INSTALL FRONT SEAT OUTER LEG COVER RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Separate Seat Type)>REASSEMBLY
71139N
10.INSTALL FRONT SEAT INNER LEG COVER RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Separate Seat Type)>REASSEMBLY
11.INSTALL FRONT SEAT ASSEMBLY RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Separate Seat Type)>INSTALLATION
12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)
for 7GR-FKS:
for 1GD-FTV:
13. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL (w/ Front Seat Side Airbag)
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
14. PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Front Seat Side Airbag)
15.CHECK SRS WARNING LIGHT (w/ Front Seat Side Airbag)
16.INSPECT SEAT BELT WARNING SYSTEM