The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the parking brake lever sub-assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
for Type A: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type A)>PRECAUTION
for Type B: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION
for Type C: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type C)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.REMOVE FRONT SEAT ASSEMBLY LH (for Separate Seat Type)
3.REMOVE FRONT SEAT ASSEMBLY LH (Sliding Bench Seat Type)
4.REMOVE FRONT SEAT ASSEMBLY RH (Fixed Bench Seat Type)
58902C
5.REMOVE CONSOLE BOX MOUNTING BRACKET SUB-ASSEMBLY (for Separate Seat Type)
58904B
6.REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY (except Separate Seat Type)
58997
7.REMOVE NO. 3 CONSOLE BOX MOUNTING BRACKET (except Separate Seat Type)
46441
8.LOOSEN NO. 1 WIRE ADJUSTING NUT
Release the parking brake lever lock and return it to its off position.
| *1 | Lock Nut |
| *2 | No. 1 Wire Adjusting Nut |
Remove the lock nut and loosen the No. 1 wire adjusting nut.
46201E
9.REMOVE PARKING BRAKE LEVER SUB-ASSEMBLY
for LHD:
Disconnect the parking brake switch connector.
for RHD:
Disengage the clamp and disconnect the parking brake switch connector.
Remove the 3 bolts and parking brake lever sub-assembly.
Remove the parking brake lever sub-assembly with the floor carpet folded back.
Remove the clip and separate the No. 1 parking brake cable assembly.
Remove the clip with the floor carpet folded back.
| *a | Claw |
|
Lift up |
Bend the claw so that the No. 1 parking brake cable assembly can be removed.
Remove the No. 1 parking brake cable assembly from the parking brake lever sub-assembly.