Refer to DTC P202A12.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P202A19 | Reductant Tank Heater Control Circuit Performance Circuit Current Above Threshold | When the tank heater is operating (temperature sensor value is equal to or less than a fixed value), overcurrent is detected multiple times (1 trip detection logic). | Urea pump | Comes on | DTC stored | SAE Code: P209F |
| P20B919 | Reductant Heater "A" Control Circuit Performance Circuit Current Above Threshold | When the urea tube with heater is operating (ambient temperature sensor value is equal to or less than a fixed value), overcurrent is detected multiple times (1 trip detection logic). | Urea tube with heater assembly | Comes on | DTC stored | SAE Code: P20BA |
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P202A19 | Reductant Tank Heater (Active Test) |
| P20B919 | Reductant Pipe Heater (Active Test) |
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P202A19 or P20B919 is output | A |
| DTC P202A19 or P20B919 and other DTCs are output* | B |
*: If any other DTCs (CAN communication malfunctions or open/short circuits) are output, perform troubleshooting for those DTCs first.
A
B
Check around the bottom of the vehicle.
If the urea solution dries on an object, deposition occurs and leaves behind a white powder.
Area to check:
Areas connecting the urea pump and urea injector set.
Perforations in the urea tank sub-assembly.
Connectors not connected properly.
Clogging of the cooling fins of the urea injector set.
If the cooling fins are clogged with foreign matter, remove the foreign matter and clean the cooling fins.
Repair any trouble areas.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs.
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Active Test / Reductant Pump Check (Backward).
| Tester Display |
|---|
| Reductant Pump Check (Backward) |
Perform the Active Test.
Enter the following menus: Powertrain / Engine / Active Test / Reductant Purge.
| Tester Display |
|---|
| Reductant Purge |
Perform the Active Test.
Perform the Reductant Purge to draw the urea solution back into the urea tank sub-assembly from the urea injector set.
| Proceed to |
|---|
| NEXT |
NEXT
Enter the following menus: Powertrain / Engine / Active Test / Reductant Tank Heater.
| Tester Display |
|---|
| Reductant Tank Heater |
Perform the Active Test.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P202A19 is output | A |
| No DTC is output | B |
A
B
Replace the urea pump.
Click hereEngine / Hybrid System>1GD-FTV (EMISSION CONTROL)>UREA PUMP>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Enter the following menus: Powertrain / Engine / Active Test / Reductant Pipe Heater.
| Tester Display |
|---|
| Reductant Pipe Heater |
Perform the Active Test.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P20B919 is output | A |
| No DTC is output | B |
A
B
Replace the urea tube with heater assembly.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Clear the DTCs.
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON and turn the GTS on.
Using the GTS, perform the following Active Tests.
To check DTC P202A19:
Enter the following menus: Powertrain / Engine / Active Test / Reductant Tank Heater.
| Tester Display |
|---|
| Reductant Tank Heater |
To check DTC P20B919:
Enter the following menus: Powertrain / Engine / Active Test / Reductant Pipe Heater.
| Tester Display |
|---|
| Reductant Pipe Heater |
Enter the following menus: Powertrain / Engine / Trouble Codes.
Confirm that the DTC is not output again.
| Proceed to |
|---|
| NEXT |
NEXT